Sony CD145 manual How to set the ring Volume, How to activate/deactivate Keypad lock

Page 26

3Press one of the digit keys

from through to select your desired ring melody

4Press to save the settings

5.5.3How to set the ring

volume

Three ring volume levels are available for your selection.

1Press

2Press

•The current ring volume level is played and displayed.

3Press one of the digit keys

from through to select your desired ring volume level

4Press to save the settings

Tip

You can press and hold	to
turn off the ringer.	will
display.

5.5.4How to set the

earpiece volume Three earpiece volume levels are available for your selection.

1Press

2Press

•The current earpiece volume level is displayed.

3Press (low), (medium) or (high) to select your desired earpiece volume level

4	Press	to save the
	settings

5.5.5How to activate/deactivate

the keypad lock

1Press and hold

• is displayed if keypad

lock is activated.

2 Press and hold again to deactivate the keypad lock

•will be disappeared if

keypad lock is deactivated.

Tip

You can also deactivate the keypad lock by removing and replacing the batteries of the handset.

5.5.6How to select recall

time

Recall time is the time delay by which the line will be disconnected after you press

.The default value of recall time preset in your CD145 should be the best suited for your country network.You do not need to change it.

24	Use more of your phone

Image 26

Contents CD145 EN Digital Cordless TelephonePage Table of contents Answering machine How to change the remote PINDefault settings Frequently asked questions Power requirements Easily accessibleDisposal instructions for batteries National recovery & recycling systemUse one of the following disposal options Using GAP standard compliance Electric, Magnetic and Electromagnetic Fields EMFPage Line cord What’s in the boxTelephone handset Base station BatteriesTalk key Overview Phone Handset ACall Log keyPhonebook key Redial/Flash keyCall Transfer / Intercom / Conference Alphanumeric keypad GStar keyHHash key Program keyDisplay icons on the handset Event LED Forward key Delete key Base stationBackward key + / keyGetting started Connect the base StationConfigure your Phone Install rechargeable BatteriesSlide out the battery cover Place the batteries as Appear on the screen Country setting tablePress Tip Direct dialling Make a call PrediallingCall is initiated Call from the call LogDisplay shows the last number dialled Call from the phonebookCall from the redial list End a callHow to use Intercom How to make a second call During a callHow to answer a Second call RecallCalled handset rings if it is available How to make an Internal callPress on the called handset Conference call is initiatedExternal call is put on hold automatically How to find a handsetDuring the conference call Is shown on the display How to adjust earpiece volume During a callCall in progress Mute/Unmute microphone During a call Number is saved Selected memory locationHow to delete the entire phonebook How to access the phonebook Idle modeHow to edit the phonebook entry or Delete a number All the phonebook entries are deletedHow to access the redial list How to access the call logHow to delete the entire call log Settings How to set the time 1 PressHow to activate/deactivate Keypad lock How to set the ring VolumeHow to set How to select recall TimeHow to turn on/turn off the key Tone How to select dial ModeCurrent settings are displayed How to set the auto prefixHow to access your voice mail number How to change the master PINHow to program voice mailbox number New PIN is savedHow to restore to default settings Your phone is reset to its default settingsHow to record your outgoing message How to turn offHow to set answer delay How to select the default outgoing Message How to play Outgoing messageHow to delete outgoing message Country setting table on SectionHow to play Incoming messagesPress and hold for two Seconds to delete all old messages How to screen an incoming callHow to remotely access your Keys Description How to change the remote PINNew remote access PIN Is saved Default settings Items Default valuesCommunication is lost during a call Connection Handset does not switch onPhone does not work at all Poor audio qualityCall Waiting call cannot be answered AppearsSet-up Caller ID does not work properly Handset displays nothing, but only the is blinkingPhonebook entry cannot be stored Caller does not hear meNoise interference on your radio or television Handset is unable to registerUnable to perform remote operation