Sharp YO-P20hII Battery Replacement, Precautions, When the LOW Battery Symbol Appears

Page 29

Battery Replacement

Batteries used

Type

Model

Quantity

Use

Lithium battery

CR2032

2

Unit operation

and backlighting

 

 

 

 

 

 

 

Be sure to write down any important information stored in the memory before replacing the batteries.

Precautions

Since improper use of the batteries may cause leakage or explosion, strictly observe the following instructions:

If fluid from a leaking battery accidentally gets into your eyes, it may result in serious injury. Should this occur, flush your eyes with clean water and consult a physician immediately.

Should fluid from a leaking battery come into contact with your skin or clothes, immediately wash with clean water.

If the Organizer will not be used for an extended period of time, to avoid damaging the Organizer remove batteries and store in a safe place.

Do not leave exhausted batteries inside the Organizer.

Do not use different types of batteries or partially used batteries.

Insert the battery with its positive side (+) correctly oriented.

Never throw batteries into a fire because they might explode.

Keep batteries out of reach of children.

When batteries become near exhaustion, remove them from the Organizer immediately to avoid battery leakage and corrosion inside the Organizer.

Because the batteries in the Organizer were installed at the factory, they may become exhausted before the specified expiration time is reached.

When the “LOW BATTERY” Symbol Appears

When “LOW BATTERY” is displayed, immediately replace the operation battery with a new one.

The operation battery holder is indicated as “For OPERATION” in the battery compartment.

If the battery level is low, the alarm may not sound, or similarly the Backlight may not function or remain on for less than the set interval. Continued use of the Organizer with low battery can alter or clear the memory contents. Memory contents may be lost if the battery is improperly replaced or if the following instructions are disregarded.

Note:

After the battery replacement, check also that the Backlight functions properly.

Caution:

PC Link may not be available when the battery level is low.

Under the low battery condition, new data entry and editing of existing data may not be performed in some modes. Also clock settings, step count function of the pedometer, and the calorie calculation may not be available.

When the Backlight Won’t Function

When the Backlight cannot be turned on (except when “LOW BATTERY” is displayed or the Organizer is in the PC Link mode), replace the battery for the backlight (“For BACKLIGHT & OPERATION”).

The backlight and operation battery holder is indicated as "For BACKLIGHT & OPERATION" in the battery compartment.

27

Image 29
Contents YO-P20HII Page Key Assignments Part NamesPart Names Alphabet entry mode Using the Organizer for the First TimeEntering symbols and letters with an accent mark Entering CharactersMaking corrections Clock ModeBefore setting the clock Changing the cities between Home and World clocks Setting the clockUsing World clock Setting alarms Setting daylight saving time DST summer timeSetting/Changing the daily alarm time Turning the alarms on and offStoring telephone entries Telephone ModeTurning the each daily alarm on and off Storing schedule entries Schedule ModeAlarm for Schedule mode Memo Mode To Do ModeStoring To Do entries Done Completed ItemsSequential search Checking details of entries in Telephone modeDirect search Sorting orderCalculation Calculator ModeEditing or deleting entries Converting currency/unit Currency/Unit Conversion ModeSetting a currency rate Blackjack Twenty-one Game ModeWord Translator Mode Diet Function Mode Spell Checker ModeTap ABC once or twice to enter the Spell Checker Mode Searching a word with ambiguous spellingMeasuring your stride length User Profile ModePositioning the unit Cover ClipUnit may not count steps correctly if you Pedometer ModeSet the pedometer to ON/OFF. To count steps, set it to on Total step countIntake Mode Consumption ModeFood Database Mode Press Enter to register the entries Report ModeBMI Calculation Mode Backlight function Deleting all the memory contentsMemory Storage Checking memory storageRegistering a password Adjusting the LCD contrastRegistering a password Managing the Organizer’s MemoryTurning Secret function off Changing the passwordDeleting the password Minimum System Requirements Using the Included PC SoftwareInstalling Serial Port SetupSynchronization action Synchronization SoftwareDesktop Utilities This tab allows you to change settings for the serial portTo add or modify the Food Database, follow the steps below Precautions Battery ReplacementWhen the LOW Battery Symbol Appears When the Backlight Won’t FunctionReplacing the batteries SpecificationsPower supply Diet Function ModePower consumption 0.13 W Declaration of Conformity Memo Memo Product Support Sharp Electronics Corporation