Sanyo CLT-A5832, CLT-A5822 Recycling NICKEL-METAL Hydride Batteries, Power Failure

Page 21

CHANGING THE BATTERY

Make sure the telephone is off before you replace the battery.

1.Slide off the battery compartment cover.

2.Disconnect the battery plug from the jack in the compartment and remove the battery pack.

3.Insert the new battery pack and connect the cord into the jack.

Note: Please refer to the pictures on page 6, “Battery setup” for guide.

4.Put the battery compartment cover back on.

5.Place handset on the base to charge for 12 hours.

Note: If the handset battery is removed for more than 5 minutes, the directory memory and caller ID memory will be erased.

Charge the handset battery for 12 continuous hours prior to first use. The initial battery charge is important for best performance.

Caution: To reduce the risk of fire or personal injury, use a NI-MH 3.6 V, 600mAh battery.

Replacement part number : GES-PC3F03

RECYCLING NICKEL-METAL HYDRIDE

BATTERIES

NICKEL-METAL HYDRIDE BATTERIES MUST BE DISPOSED OF PROPERLY. Please take your used battery pack to a store that recycles

Ni-MH batteries.

POWER FAILURE

When power is off, you will not be able to make or receive calls with the telephone.

After a power outage, place the handset in the base for about 20 seconds to reset the digital security code.

21

sy5822 10 april.p65

21

2006/5/12, ¤U¤È 02:52

Image 21

Contents CLT-A5830 Table of Contents Caller ID Features Main Features GHz Technology Other featuresIntroduction Checking package contents Getting StartedModular jack Connecting the base unit and charging the handset Battery setupTelephone line connection Tone/pulse settingRegister handsets to the main base before use To register the second handset for CLT-A5822 and CLT-A5832Handset Names and ControlsBase Unit Charger For CLT-A5822 and CLT-A5832 Area code setting Language settingInitial Programming Ringer toneResetting to default BasicsReceiving a call Ringer switch Volume adjustmentMaking a call Transferring a call For CLT-A5822 and CLT-A5832Changing the pre-dial number Pre-dialing up to 32 digitsRedialing Fast redialingTone key Low battery warningHandset locator Paging function Mute keyCaller ID Features Voice mail indicatorCaller ID with Call Waiting Caller ID list Reviewing Caller ID listFormatting Caller ID numbers Dialing a Caller ID number Storing Caller ID entries in the directoryDeleting entries from the Caller list Deleting the displayed entryDirectory Deleting all entriesStoring a number in the directory Replacing a directory entry with a Caller ID entry Reviewing and deleting directory contentsChanging a stored number Making calls from the directoryChanging the Battery Battery replacement and handlingChain dialing from the directory Recycling NICKEL-METAL Hydride Batteries Power FailureBelt clip installation Light SignalsHeadset Jack and Belt Clip CHARGE/IN USE LED on the baseLCD Screen Messages ErrorSound Signals TroubleshootingCaller ID Telephone Troubleshooting Troubleshooting Maintenance Charge it for a full 12 hours Maximize Battery PerformanceNoise Technical InformationRange InterferenceTechnical Information Warranty Application Sanyo Comfort WarrantyWhat is not Covered Sanyo Canada INC.’S ResponsibilityHOW to Obtain Warranty Service Warranty Becomes VoidOriginal Retail PURCHASER’S Responsibility Statutory WarrantiesSOS Help Line Guaranteed QualityNationwide Customer Support STAY-AT-HOME Convenience