VTech cs5121 important safety instructions Battery

Page 48

Battery

After the battery is fully charged for 16 hours, you can expect the following performance:

 

Operation

Operating time

 

 

 

 

While in use (talking)

Five hours

 

 

 

 

While not in use (standby*)

Six days

 

 

 

*Handset is off the telephone base but not in use.

 

The battery needs charging when:

 

A new battery is installed in the handset.

The handset beeps.

LOW BATTERY is displayed and the battery indicator on the handset screen is flashing.

CAUTION:

To reduce the risk of fire or injury to persons, read and follow these instructions:

Use only the battery(ies) provided or equivalent. To order a replacement, visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.

Do not dispose of the battery(ies) in a fire. Check with local waste management codes for special disposal instructions.

Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.

Exercise care in handling batteries in order not to create a short circuit with conductive materials such as rings, bracelets, and keys. The battery and/or conductor may overheat and cause burns.

Charge the battery(ies) provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO WATER OR ANY TYPE OF MOISTURE.

www.vtechphones.com

45

Appendix

Image 48
Contents Important safety instructions CongratulationsTable of contents Appendix Parts checklist Getting startedTelephone base installation Battery installation and charging Mounting bracket installation Wall mounting bracket installationDesktop/tabletop bracket installation Handset layout VOL-/CIDTelephone base layout DeleteTelephone settings Date and timeRinger volume handset RingerDial mode Home area codeLanguage Telephone operation Call waiting Temporary tone dialingRedial Find handsetDirectory Store a directory entryCharacter chart Review the directoryEdit a directory entry Delete a directory entry Copy a directory entry into speed dial Dial a number from the directorySpeed dial Store a speed dial entryEdit a speed dial entry Delete a speed dial entry Dial a speed dial numberReassign speed dial locations About caller ID Call log Review the call log Make call log entries ready to dialDial a call log number Save a call log entry to the directory Entries ready to dial section onDelete from the call log Delete an entryCall log display screen messages Displays WhenAnswering system Message capacityActivate the answering system Set the clockAnswering system setup Set number of ringsSet remote access code Set telephone base ringerSet message alert tone Outgoing announcement Play your announcementRecord your own announcement Delete your announcementNew message indication Message playbackOptions during playback Delete all messages Record and play memosRecord a memo Memo playbackCall screening Call interceptMessage window displays Window displays WhenRemote access Command FunctionHandset display screen messages Handset ringer is turned off Battery Important safety instructions Troubleshooting Problem SuggestionCharge light is off in this section Connecting To take place Your area. See Dial mode on page 10 to set the dial type Telephone company charges may apply Remove and re-insert the battery Dial or store from the call log Troubleshooting Troubleshooting Maintenance Operating rangeWarranty About cordless telephonesHow do you get warranty service? FCC, Acta and IC regulations FCC PartRbrc seal Technical specifications Index Temporary tone dialing  91-001378-050-100 User’s manual