VTech cs5121 important safety instructions Troubleshooting, Problem Suggestion

Page 50

Troubleshooting

If you have difficulty with your telephone, please try the suggestions below. For Customer Service, visit our website at www.vtechphones.com, or call 1 (800) 595-9511; in Canada, call 1 (800) 267-7377.

Problem

Suggestion

My telephone does not

Make sure the battery is installed and charged correctly (page 3). For optimum daily

work at all.

 

performance, return the handset to the telephone base after use.

 

Make sure the power adapter is securely plugged into an outlet not controlled by a wall

 

 

switch.

 

• Make sure the telephone line cord is plugged firmly into the telephone base and the wall jack.

 

Unplug the unit’s electrical power. Wait for approximately 15 seconds, then plug it back in.

 

 

Allow up to one minute for the handset and telephone base to synchronize.

 

• Charge the battery in the handset for at least 16 hours.

 

• Remove and re-insert the battery. If that still does not work, it may be necessary to purchase

 

 

a new battery.

 

• Disconnect the telephone base from the jack and plug in a working telephone. If this telephone

 

 

does not work, the problem is probably in the wiring or the local service. Call the local telephone

 

 

company.

LOW BATTERY is

Place the handset in the telephone base or charger for recharging.

displayed on screen.

Remove and re-install the battery and use it normally until fully depleted, then recharge the

 

 

handset on the telephone base for 16 hours.

 

• If the above measures do not correct the problem, the battery may need to be replaced.

 

 

 

www.vtechphones.com

47

Appendix

Image 50
Contents Important safety instructions CongratulationsTable of contents Appendix Parts checklist Getting startedTelephone base installation Battery installation and charging Mounting bracket installation Wall mounting bracket installationDesktop/tabletop bracket installation Handset layout VOL-/CIDTelephone base layout DeleteTelephone settings Date and timeRinger volume handset RingerDial mode Home area codeLanguage Telephone operation Call waiting Temporary tone dialingRedial Find handsetDirectory Store a directory entryCharacter chart Review the directoryEdit a directory entry Delete a directory entry Copy a directory entry into speed dial Dial a number from the directorySpeed dial Store a speed dial entryEdit a speed dial entry Delete a speed dial entry Dial a speed dial numberReassign speed dial locations About caller ID Call log Review the call log Make call log entries ready to dialDial a call log number Save a call log entry to the directory Entries ready to dial section onDelete from the call log Delete an entryCall log display screen messages Displays WhenAnswering system Message capacityActivate the answering system Set the clockAnswering system setup Set number of ringsSet remote access code Set telephone base ringerSet message alert tone Outgoing announcement Play your announcementRecord your own announcement Delete your announcementOptions during playback New message indicationMessage playback Record a memo Delete all messagesRecord and play memos Memo playbackCall screening Call interceptMessage window displays Window displays WhenRemote access Command FunctionHandset display screen messages Handset ringer is turned off Battery Important safety instructions Troubleshooting Problem SuggestionCharge light is off in this section Connecting To take place Your area. See Dial mode on page 10 to set the dial type Telephone company charges may apply Remove and re-insert the battery Dial or store from the call log Troubleshooting Troubleshooting Maintenance Operating rangeWarranty About cordless telephonesHow do you get warranty service? FCC, Acta and IC regulations FCC PartRbrc seal Technical specifications Index Temporary tone dialing  91-001378-050-100 User’s manual