VTech VT9127 Handset does not Ring When YOU Receive a Call, Your Caller Fades in and OUT

Page 22

ADDITIONAL INFORMATION

IN CASE OF DIFFICULTY

THE HANDSET DOES NOT RING WHEN YOU RECEIVE A CALL.

•Ensure that the ringer is turned on.

•Make sure the telephone line cord is plugged firmly into the Base Unit and the telephone jack. Make sure the power cord is plugged in.

•You may be too far from the Base Unit.

•You may have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of the other phones.

YOUR CALLER FADES IN AND OUT.

•You may be nearly out of range. Move closer, or relocate the Base.

YOU HEAR OTHER CALLS WHILE USING YOUR PHONE.

•Press PROG/CHAN key to switch to another channel.

•Disconnect your Base unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company.

YOU HEAR NOISE IN THE HANDSET, AND NONE OF THE KEYS OR BUTTONS WORK.

•Make sure the power cord is plugged in.

•Your Base Unit and Handset may not be operating on the same channel. Place the Handset in the cradle for a few moments to reset the channel.

COMMON CURE FOR ELECTRONIC EQUIPMENT

Electronics, like people, can sometimes get confused. If the unit does not seem to be responding normally, then try putting the Handset in the cradle to re-initialize the unit. If it still does not seem to respond, perform the following steps (in the order listed):

1.Disconnect the power to the Base.

2.Disconnect (remove) the Handset battery.

3.Wait a few minutes.

4.Connect power to the Base.

5.Install the Handset battery pack.

6.Put the Handset in the Base to re-initialize. If the Handset has not been recently charged, allow 16 hours before use.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Table of Contents Important Safety Instructions Parts Check List Handset Layout Base Layout Installation of Battery Pack in Handset Follow these InstructionsSetting UP Your VT9127 TONE/PULSE Selection Ringer SelectionPress PROG/CHAN Handset is in idle mode Handset DisplayMaking Calls Volume ControlBasic Operation Channel ChangingAnswering Calls Using RedialFlash Hold About Caller ID Caller ID/CALL Waiting IDReceiving and Storing Calls Review Caller IDDial a Displayed Number Deleting Records from Call HistoryStore a Caller ID Record in Phone Book Memory Display Screen Messages ErrPhone Book Store Memory NumbersDelete Numbers Stored in Memory Edit Numbers Stored in MemoryDial Memory Numbers Message Waiting Until Messages Waiting isOperation Belt Clip InstallationDo not pull up from the bottom of the clip Avoid Rough Treatment MaintenanceCleaning Your Telephone Avoid WaterNo Dial Tone Case of DifficultyPhone DOESN’T Work AT ALL Vtech Communications atYour Caller Fades in and OUT Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Common Cure for Electronic EquipmentLimited Warranty What does this limited warranty cover?How do you get warranty service? LimitationsFCC, Acta and IC Regulations VTech Communications IncConnection and use with the nationwide telephone network Rbrctm Seal Technical Specifications Page Issued
Top Page Image Contents