VTech VT9127 Installation of Battery Pack in Handset, Follow these Instructions

Page 6

GETTING STARTED

INSTALLATION OF BATTERY PACK IN HANDSET

The Handset of your VT9127 is powered by a rechargeable battery pack. It charges automatically whenever the Handset is in the Base Unit. The battery pack needs charging when:

•The low battery icon and message are displayed:

•A double beep is generated.

To charge the battery pack, place the Handset in the Base Unit. The IN USE/CHARGING indicator will light to show the Handset is seated properly and the battery pack is charging. It is recommended that the battery pack should be charged for at least 16 hours initially. Afterwards, 8 hours of maintenance charging should be sufficient.

To install (or replace) the battery pack, follow the steps below:

1.Remove the battery case cover by pressing on the ridged lines and sliding downward.

2.Discard the old battery pack by pulling firmly on the battery cords. Don’t put the old battery pack in a trash compactor or a fire - it could burst. Please recycle.

3.Snap in the new battery pack, with the wires in one of the lower corners. Insert the battery plug into the socket, aligning the two holes in the plug with the socket pins.

4.Replace the battery case cover by sliding the cover upwards.

5.Place the Handset in the cradle of the Base Unit to allow

it to charge for 16 hours.

CAUTION: To Reduce the Risk of Fire or Injury, Read and

Follow these Instructions:

IMPORTANT:

Do not dispose of this battery pack into household garbage. For information on recycling or proper disposal, consult your local solid waste collection or disposal organization.

1.Use only VTech rechargeable battery pack, or equivalent.

2.Do not dispose of the battery pack in a fire. The cell may

explode.

3.Do not open or mutilate the battery pack. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

4.Exercise care in handling batteries in order not to short the

battery with conducting materials such as rings, bracelets, and keys. The battery pack or conductor may overheat and cause burns.

To purchase replacement battery packs, call VTech at 1-800-595-9511. In Canada, call 1-800-267-7377.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Table of Contents Important Safety Instructions Parts Check List Handset Layout Base Layout Installation of Battery Pack in Handset Follow these InstructionsSetting UP Your VT9127 Ringer Selection TONE/PULSE SelectionPress PROG/CHAN Handset is in idle mode Handset DisplayMaking Calls Volume ControlBasic Operation Channel ChangingUsing Redial Answering CallsFlash Hold About Caller ID Caller ID/CALL Waiting IDReceiving and Storing Calls Review Caller IDDeleting Records from Call History Dial a Displayed NumberStore a Caller ID Record in Phone Book Memory Display Screen Messages ErrPhone Book Store Memory NumbersEdit Numbers Stored in Memory Delete Numbers Stored in MemoryDial Memory Numbers Message Waiting Until Messages Waiting isInstallation Operation Belt ClipDo not pull up from the bottom of the clip Avoid Rough Treatment MaintenanceCleaning Your Telephone Avoid WaterNo Dial Tone Case of DifficultyPhone DOESN’T Work AT ALL Vtech Communications atYour Caller Fades in and OUT Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Common Cure for Electronic EquipmentLimited Warranty What does this limited warranty cover?How do you get warranty service? LimitationsFCC, Acta and IC Regulations VTech Communications IncConnection and use with the nationwide telephone network Rbrctm Seal Technical Specifications Page Issued
Top Page Image Contents