VTech important safety instructions Setting UP Your VT9127

Page 7

SETTING UP YOUR VT9127

1.Plug the AC adaptor into an electrical outlet, and the AC connector to the bottom of the Base Unit. If the Handset battery pack has not been charged previously, place the Handset in the Base Unit cradle, and allow it to charge for 16 hours.

2.Connect the telephone line cord to the jack on the bottom of the Base Unit, and the other end to the wall jack.

9V AC

TEL.

A fully charged battery pack will provide a maximum talk time

of 4.5 hours, with a maximum standby (off cradle) time of 6

days.

7

GETTING STARTED

Image 7

Contents Table of Contents Important Safety Instructions Parts Check List Handset Layout Base Layout Follow these Instructions Installation of Battery Pack in HandsetSetting UP Your VT9127 TONE/PULSE Selection Ringer SelectionPress PROG/CHAN Handset Display Handset is in idle modeChannel Changing Volume ControlBasic Operation Making CallsAnswering Calls Using RedialFlash Hold Review Caller ID Caller ID/CALL Waiting IDReceiving and Storing Calls About Caller IDDial a Displayed Number Deleting Records from Call HistoryStore a Caller ID Record in Phone Book Memory Err Display Screen MessagesStore Memory Numbers Phone BookDelete Numbers Stored in Memory Edit Numbers Stored in MemoryDial Memory Numbers Until Messages Waiting is Message WaitingOperation Belt Clip InstallationDo not pull up from the bottom of the clip Avoid Water MaintenanceCleaning Your Telephone Avoid Rough TreatmentVtech Communications at Case of DifficultyPhone DOESN’T Work AT ALL No Dial ToneCommon Cure for Electronic Equipment Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Your Caller Fades in and OUTWhat does this limited warranty cover? Limited WarrantyLimitations How do you get warranty service?VTech Communications Inc FCC, Acta and IC RegulationsConnection and use with the nationwide telephone network Rbrctm Seal Technical Specifications Page Issued