VTech VT 1920C manual Replace the battery case cover by sliding the cover upwards

Page 10

REPLACING THE BATTERY PACK

Follow the steps below:

1.Remove the battery case cover by pressing on the ridged lines and sliding downward.

PRESS and SLIDE

DOWNWARD

2.Discard the old battery pack. Don’t put the old battery pack in a trash compactor or a fire - it could burst.

3.Place the new battery pack in its housing with the metal contacts facing down.

PLACE THE NEW

BATTERY PACK

INTO THE

BATTER

COMPARTMENT

PLEASE NOTE THE

CORRECT POSITION

OF THE BATTERY

PACK WHEN

CHANGING BATTERY

4.Replace the battery case cover by sliding the cover upwards.

SLIDE IN THE

BATTERY

COVER

5.If the new battery pack is not already charged, place the hand- set in the cradle of the base unit to allow it to charge for 16 hours.

CAUTION:

To Reduce the Risk of Fire or Injury to parsons, read and Follow the Instructions

1.Use only VTECH rechargeable battery pack.

2.Do not dispose of the battery in a fire. The cell may explode.

IMPORTANT: Do not dispose of this battery into household garbage. For information on recycling or proper disposal, consult your local solid waste collection or disposal organization.

3.Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

10

1920manual

10

1/28/99, 3:27 PM

Image 10

Contents Introduction Special Features Parts Check List VT 1920cFCC and IC Regulations FCC PartFCC and IC Regulations FCC and IC Regulations Important Safety Instructions E a d a n d u n d e r s t a n d a l l instructionsImportant Safety Instructions Charging the Handset BAT- Tery Pack Ctions Replacing the Battery PackTo Charge The Battery Pack Word about Rechargeable BatteriesReplace the battery case cover by sliding the cover upwards Spare Battery Charger InstallationPower Backup Replacing a Drained Handset bat- teryGetting Started Handset RingerFill in the telephone number card on the base unit Wall Mounting I N G T H E WA L L M O U N T AdaptorLCD Display LCD Display MessagesHandset Features Handset LayoutBase Unit Features Base Unit LayoutQuick Reference Guide CID Caller ID Using RedialMemory Dialing Speed Dialing HoldBasic Operation Call Waiting Advanced FunctionsCID-CALLER ID Turning Off The Ringer Changing Ringer TypesChecking The Ringer Type CLR/DEL Key FunctionAdvanced Dialing Memory Dialing Storing Memory Speed Dial numbersDeleting Stored Numbers Dialing From MemoryChanging Stored Numbers DeletedStoring Special Codes Receiving and Storing Calls CID-CALLER IDCall Waiting Caller ID Type II CID Dialing from CID MemoryPrivate Calls Special Message Indicators Out of Area CallsTransmission Error PrivateReviewing Numbers Reviewing NumbersDeleting Numbers Additional Operating Tips OUT of Range When Phone is onOUT of Range When Phone is OFF Noise or InterferenceMaintenance Taking Care of Your TEL- EphoneCase of Difficulty Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Phone DOESN’T Work AT ALLCommon Cure for Electronic Equipment Warranty Statement What does OUR Warranty not COVER? Technical Specifications Table of Contents Issue