VTech VT 1920C manual Memory Dialing, Storing Memory Speed Dial numbers

Page 25

MEMORY DIALING

Storing Memory (Speed) Dial numbers

To program a speed dial location, do the following:

•With the phone OFF, enter the telephone number you wish to store. (20 Digits Maximum).

•Enter program mode by pressing PROG. The display will show the following:

•Enter the memory location (01..20) you wish to store the number in. As soon as the second memory location digit is entered, the unit will emit a happy tone (a short series of beeps) to confirm successful programming and exit program mode.

	FLASH	PAUSE		STORING SPEED DIAL
	PHONE	HOLD	OFF	NUMBERS
	1	2 abc	3 def	DIAL YOUR PHONE
	4 ghi	5 jkl	6 mno	DIAL YOUR PHONE
	4 ghi	5 jkl	6 mno	NUMBER
	7 pqrs	8 tuv	9 wxyz	PRESS PROG
	*	0oper	#	PRESS PROG
	*
	tone
	MEM	CID	REDIAL	PRESS LOCATION
	PROG	CLR/DEL	MUTE	(01-20)

Unsuccessful programming can result from not correctly completing the programming sequence. For example, if after entering a number on the LCD and entering program mode, the OFF key were pressed instead of entering a valid memory location, the

"PROGRAMMING INCOMPLETE" message would appear. If this message appears, simply repeat the programming sequence.

If programming is unsuccessful the unit will display:

25

1920manual

25

1/28/99, 3:28 PM

Image 25

Contents Introduction Special Features VT 1920c Parts Check ListFCC Part FCC and IC RegulationsFCC and IC Regulations FCC and IC Regulations E a d a n d u n d e r s t a n d a l l instructions Important Safety InstructionsImportant Safety Instructions To Charge The Battery Pack Ctions Replacing the Battery PackCharging the Handset BAT- Tery Pack Word about Rechargeable BatteriesReplace the battery case cover by sliding the cover upwards Installation Spare Battery ChargerReplacing a Drained Handset bat- tery Power BackupHandset Ringer Getting StartedFill in the telephone number card on the base unit I N G T H E WA L L M O U N T Adaptor Wall MountingLCD Display Messages LCD DisplayHandset Layout Handset FeaturesBase Unit Layout Base Unit FeaturesQuick Reference Guide Memory Dialing Speed Dialing Using RedialCID Caller ID HoldBasic Operation Call Waiting Advanced FunctionsCID-CALLER ID Checking The Ringer Type Changing Ringer TypesTurning Off The Ringer CLR/DEL Key FunctionAdvanced Dialing Storing Memory Speed Dial numbers Memory DialingChanging Stored Numbers Dialing From MemoryDeleting Stored Numbers DeletedStoring Special Codes Call Waiting Caller ID Type II CID CID-CALLER IDReceiving and Storing Calls Dialing from CID MemoryTransmission Error Special Message Indicators Out of Area CallsPrivate Calls PrivateReviewing Numbers Reviewing NumbersDeleting Numbers OUT of Range When Phone is OFF OUT of Range When Phone is onAdditional Operating Tips Noise or InterferenceTaking Care of Your TEL- Ephone MaintenanceYOU Hear Other Calls While Using Your Phone Handset does not Ring When YOU Receive a CallCase of Difficulty Phone DOESN’T Work AT ALLCommon Cure for Electronic Equipment Warranty Statement What does OUR Warranty not COVER? Technical Specifications Table of Contents Issue