VTech VT 1920C manual Technical Specifications

Page 38

TECHNICAL SPECIFICATIONS

FREQUENCY CONTROL

Crystal Controlled Dual PLL Synthesizer

TRANSMIT FREQUENCY

Handset : 925.05 MHz to 927.75 MHz ( All ten channels within this range)

Base : 902.3 MHz to 905.0 MHz (All ten channels within this range)

RECEIVE FREQUENCY

Handset : 902.3 MHz to 905.0 MHz ( All ten channels within this range)

Base : 925.05 MHz to 927.75MHz ( All ten channels within this range)

WEIGHT

Handset : 250 grams

Base : 415 grams

POWER REQUIREMENTS

Handset : Self-contained nickel- cadmium rechargeable battery supply, 3 . 6V nominal, 600mAh capacity.

Base: 9VDC @ 300mA

MEMORY

Speed Dial:20 Memory locations, 20 digits per location.

CID	: Alpha Numeric Display 50
	Memory locations

NOMINAL EFFECTIVE RANGE Maximum power allowed by FCC and IC. Actual operating range may vary according to environmental conditions at the time of use.

SIZE

Handset : 19 x 6 x 3.5cm (L x W xT) Maximum (Antenna ex- cluded)

SPECIFICATIONS ARE TYPICAL AND MAY CHANGE WITHOUT NOTICE.

Base : 21.5 x 14.5 x 5cm (L x W x T) Maximum (Antenna excluded)

38

1920manual

38

1/28/99, 3:28 PM

Image 38

Contents Introduction Special Features Parts Check List VT 1920cFCC and IC Regulations FCC PartFCC and IC Regulations FCC and IC Regulations Important Safety Instructions E a d a n d u n d e r s t a n d a l l instructionsImportant Safety Instructions Charging the Handset BAT- Tery Pack Ctions Replacing the Battery PackTo Charge The Battery Pack Word about Rechargeable BatteriesReplace the battery case cover by sliding the cover upwards Spare Battery Charger InstallationPower Backup Replacing a Drained Handset bat- teryGetting Started Handset RingerFill in the telephone number card on the base unit Wall Mounting I N G T H E WA L L M O U N T AdaptorLCD Display LCD Display MessagesHandset Features Handset LayoutBase Unit Features Base Unit LayoutQuick Reference Guide CID Caller ID Using RedialMemory Dialing Speed Dialing HoldBasic Operation CID-CALLER ID Advanced FunctionsCall Waiting Turning Off The Ringer Changing Ringer TypesChecking The Ringer Type CLR/DEL Key FunctionAdvanced Dialing Memory Dialing Storing Memory Speed Dial numbersDeleting Stored Numbers Dialing From MemoryChanging Stored Numbers DeletedStoring Special Codes Receiving and Storing Calls CID-CALLER IDCall Waiting Caller ID Type II CID Dialing from CID MemoryPrivate Calls Special Message Indicators Out of Area CallsTransmission Error PrivateReviewing Numbers Reviewing NumbersDeleting Numbers Additional Operating Tips OUT of Range When Phone is onOUT of Range When Phone is OFF Noise or InterferenceMaintenance Taking Care of Your TEL- EphoneCase of Difficulty Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Phone DOESN’T Work AT ALLCommon Cure for Electronic Equipment Warranty Statement What does OUR Warranty not COVER? Technical Specifications Table of Contents Issue