VTech CS5123 user manual Troubleshooting

Page 60

Troubleshooting

Problem

Suggestion

 

 

 

The messages on

Press VOL+ on the telephone base to increase the speaker volume.

the system are very

 

 

difficult to hear.

 

 

 

 

 

My cordless handset

Make sure the power cord is securely plugged into the telephone base. Plug the unit into a

beeps and is not

 

different working electrical outlet not controlled by a wall switch.

performing normally.

Move the handset closer to the telephone base. It may be out of range.

 

Reset the telephone base by unplugging the unit’s electrical power. Wait for 15 seconds

 

 

and plug it back in again. Allow up to one minute for the handset and the telephone base to

 

 

synchronize.

 

Other electronic products can cause interference to your cordless telephone. Try installing

 

 

your telephone as far away from these electronic devices as possible: wireless routers, radios,

 

 

radio towers, pager towers, cellular telephones, intercoms, room monitors, televisions, personal

 

 

computers, kitchen appliances and other cordless telephones.

 

 

 

Common cure for

If the unit is not responding normally, try putting the handset in the telephone base. If it does

electronic equipment

 

not respond, try the following (in the order listed):

 

• Disconnect the power to the telephone base.

 

• Disconnect the battery on the handset.

 

• Wait a few minutes before connecting the power to the telephone base.

 

Re-install the battery and place the handset into the telephone base.

 

• Wait for the handset to synchronize with the telephone base. Allow up to one minute for this

 

 

to take place.

 

 

 

56

www.vtechphones.com

Image 60
Contents User’s manual Important safety instructions CongratulationsTable of contents Appendix Parts checklist Getting startedTelephone base installation Battery installation and charging Mounting bracket installation Wall mounting bracket installationDesktop/tabletop bracket installation Handset layout VOL-/CIDTelephone base layout DeleteTelephone settings Date and timeRinger volume handset RingerDial mode Home area codeLanguage Telephone operation Call waiting Temporary tone dialingRedial Find handsetDirectory Store a directory entryCharacter chart Review the directoryEdit a directory entry Delete a directory entry Copy a directory entry into speed dial Dial a number from the directorySpeed dial Store a speed dial entryEdit a speed dial entry Delete a speed dial entry Dial a speed dial numberReassign speed dial locations About caller ID Call log Review the call log Make call log entries ready to dialDial a call log number Save a call log entry to the directory Entries ready to dial section onDelete from the call log Delete an entryCall log display screen messages Displays WhenAnswering system Message capacityActivate the answering system Set the clockAnswering system setup Set number of ringsSet remote access code Set telephone base ringerSet message alert tone Outgoing announcement Play your announcementRecord your own announcement Delete your announcementNew message indication Message playbackOptions during playback Delete all messages Record and play memosRecord a memo Memo playbackCall screening Call interceptMessage window displays Window displays WhenRemote access Command FunctionHandset display screen messages Handset ringer is turned off Battery Important safety instructions Troubleshooting Problem SuggestionCharge light is off in this section Connecting To take place Your area. See Dial mode on page 10 to set the dial type Telephone company charges may apply Remove and re-insert the battery Dial or store from the call log Troubleshooting Troubleshooting Maintenance Operating rangeWarranty About cordless telephonesHow do you get warranty service? FCC, Acta and IC regulations FCC PartRbrc seal Technical specifications Index Temporary tone dialing  91-002140-020-100