WALL MOUNTING
INSERT WALL MOUNT INTO THE BASE UNIT
TONE PLUSE
1RINGER |
LINE |
LINE 2 RINGER
SNAP IN FIRMLY
SLIDE DOWN
1.Choose a spot near an electrical outlet and a telephone jack. Your phone requires a modular telephone jack and a standard electrical outlet ( 120v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the base. The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone will not operate.
2.Position the wall mount adaptor on the base. Line up the tabs on the wall mount adaptor with the holes on the bottom of the base. Snap the wall mount adaptor firmly in place.
3.Mount the base on the wall. Position the base so the mounting studs will fit into the holes on the bottom of the base. Position the power cord to extend down the wall the phone is to be mounted on. Slide the base down on the mounting studs until it locks into place.
4.Connect the telephone cord(s). The telephone line cord has a
5.Plug the AC adaptor on the power cord into an electrical outlet.
.
IMPORTANT
When wall mounting your 921 ADL, you must reverse the handset hook located in the charging cradle.
Otherwise your Handset may fall from the Base Unit when cradled.
6