RY PACK |
| GETTING STARTED |
|
TEL LINE 
9V DC | L1 or L1/L2 | L2 | |
|
|
|
|
one telephone jack (RJ 14), insert one end of the four wire (black tipped) tel- ephone line cord into the
AC ELECTRICAL OUTLET
TELEPHONE
WALL JACK
OR
jack marked L1/L2 at the rear of the Base Unit. Plug the other end into the
OR telephone wall jack. If your two telephone lines are each serviced by a separate telephone jack (RJ 11), insert one end of a tel- ephone line cord into the
SETTING UP YOUR VTECH 921 ADL
1.Choose an area near an electrical outlet and a telephone wall jack.
2.Plug the AC power adaptor into an electrical outlet and the DC connector to the back of the Base Unit.
CAUTION: Use Class 2 Power Source Only. Use only the AC adaptor shipped with your 921 ADL. This is a Class 2 AC adap- tor, specifically designed for use with the 921 ADL.
NOTE: Connect power to the Base Unit before placing the Handset in the cradle.
3.Set the TONE/PULSE switch on the Base Unit. If you have touch tone service on your phone line, set the switch to TONE. If you have rotary service, set the switch to PULSE.
4.CHARGE THE HANDSET BATTERY PACK BEFORE USE. The battery pack recharges automatically whenever the Handset is in the Base Unit cradle. The battery pack should be charged for 16 hours before using your phone for the first time.
5.Connect the telephone line cord(s). If you have two lines which are serviced by
jack marked L1/L2 (this will be your Line
1) and a second telephone cord into the jack marked L2 (this will be your Line 2) at the rear of the Base Unit. Plug the other end of the telephone cords into the ap- propriate wall jacks. Make sure the plugs snap securely into place.
6.CHECK FOR A DIAL TONE. After the battery pack is charged, raise the Base Unit Antenna to an upright position. Then, pick up the Handset and press a LINE key. The corresponding LINE LED (on the Base Unit) and the LINE key (on the Handset) will glow red, and you should hear a dial tone. If not, see IN CASE OF
DIFFICULTY.
CAUTION:
1.Never install telephone wiring during a lightning storm.
2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
4.Use caution when installing or modifying
telephone lines.
5