VTech 20-2481 important safety instructions Register, To Deregister all Handsets

Register

Handset Deregistration

You can deregister all Handsets at one time. This causes the Base Unit to ‘forget’ that it has any Handsets at all. You may never have to perform this procedure. One possible reason for deregistration is if you have the maximum number of Handsets (8) registered to your Base, and one Handset should require replacement, the Base will not register the ‘new’ Handset, because its eight memory slots are occupied. The deregistration procedure will clear the Base Unit’s memory, and you will be able to register each Handset again. Individual Handsets cannot be deregistered.

CAUTION: Once you deregister, your Handsets will not be capable of making or receiving calls. You will need to re-register each Handset, one at a time!!

To Deregister all Handsets:

·At the Base Unit, in the idle (OFF) mode, press MENU.

·Scroll down to SETUP BASE, then press OK.

·Scroll down to DEREGISTER ALL, then press SET.

All system Handsets have been deregistered. To register your Handsets again,

see Registration and Operation, located in the Getting Started section of the

User’s Manual, for details.

Basic Operation

Register

Use this option to register a Handset to the GIGAPHONE Base. You can register a total of eight Handsets to the GIGAPHONE Base. This process is activated automatically whenever a new handset is powered up in range of the GIGAPHONE Base.

You will be prompted to enter the 15-digit Base ID code. See Registration and Operation, located in the Getting Started section of the manual, for details.

Note : Base ID codes are 15 digits long and can include the following characters

: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, * , or # .

23