VTech 20-2481 Case Of Difficulty, Phone Doesnt Work At All, No Dial Tone

	In Case Of Difficulty
If you have difficulty operating your phone, the suggestions below should solve
the problem. If you still have difficulty after trying		these suggestions, call
VTECH Communications at 1-800-595-9511. In Canada, call VTECH Electronics
at 1-800-267-7377.
The Phone Doesn't Work At All
•	Make sure the Power Cord is plugged in.
•	Make sure the telephone line cord is plugged firmly into the Base Unit
	and the telephone wall jack.
•	Make sure the batteries are properly charged.	If the 'LOW BATTERY'
	message is shown, the battery pack needs charging.
•	Is the Handset registered to the Base? See Registration and Operation.
No Dial Tone
•	First check all the suggestions above.
•	If you still don't hear a dial tone, disconnect the Base Unit from the telephone
	jack and connect a different phone. If there is no dial tone on that phone
	either, the problem is in your wiring or local service. Contact your local
	telephone company.
You Get Noise, Static, Or A Weak Signal Even When You're Near The
Base Unit
•	Household appliances plugged into the same circuit as the Base Unit can
	sometimes cause interference. Try moving the appliance or the Base Unit
	to another outlet.
You Get Noise, Static, Or A Weak Signal When You're Away From
The Base Unit
•	You may be out of range. Either move closer to the Base, or relocate the
	Base Unit.
•	The layout of your home may be limiting the range. Try moving the Base
	Unit to another position.
The Handset Does Not Ring When You Receive A Call
•	Make sure you have the Handset ringer activated. To set the ringer, see
	HANDSET SETTINGS and BASE SETTINGS.
•	Make sure the telephone line cord is plugged firmly into the Base Unit
	and the telephone jack. Make sure the power cord is plugged in.
•	You may be too far from the Base Unit.	InformationAdditional
•	You may have too many extension phones on your telephone line to allow
	all of them to ring. Try unplugging some of the other phones.
	37