VTech 20-2481 important safety instructions FCC and IC Regulations, VTech Communications Inc

Page 42

 

 

FCC and IC Regulations

 

This equipment complies with Parts 15 of the Federal Communications

 

Commission (FCC) rules for the United States. It also complies with regulations

 

RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the

 

following two conditions: (1) this device may not cause interference, and (2) this

 

device must accept any interference, including interference that may cause

 

undesired operation of the device.

 

A label is located on the underside of the Base Unit containing either the FCC

 

registration number and Ringer Equivalence Number (REN) or the IC registration

 

number and Load Number. You must, upon request, provide this information

 

to your local telephone company.

 

This equipment is compatible with inductively coupled hearing aids.

 

Should you experience trouble with this telephone equipment, please contact:

 

VTech Communications Inc.

 

SERVICE DEPT. at 1-800-595-9511. In Canada, call VTECH Electronics at 1-800-

 

267-7377.

 

For repair/warranty information. The telephone company may ask you to

 

disconnect this equipment from the line network until the problem has been

 

corrected.

 

FCC Part 15

 

Warning: Changes or modifications to this unit not expressly approved by the

 

party responsible for compliance could void the user's authority to operate the

 

equipment.

 

The equipment has been tested and found to comply with part 15 of the FCC

 

rules. These limits are designed to provide reasonable protection against harmful

 

interference in a residential installation. This equipment generates, uses and can

 

radiate radio frequency energy and, if not installed and used in accordance with

 

the instructions, may cause harmful interference to radio communications.

 

However, there is no guarantee that interference will not occur in a particular

 

installation. If this equipment does cause harmful interference to radio or

 

television reception, which can be determined by turning the equipment off and

 

on, the user is encouraged to try and correct the interference by one or more

InformationAdditional

of the following measures:

•

Reorient or relocate the receiving antenna.

 

 

•

Increase the separation between the equipment and receiver.

 

•

Connect the equipment into an outlet or on a circuit different from that

 

 

to which the receiver is connected.

 

•

Consult the dealer or an experienced radio/TV technician for help.

 

 

42

Page 41 Page 43
Image 42
Page 41 Page 43
Contents Important Safety Instructions Stop Introduction Menu Driven DisplaysParts Check List Handset Layout Base Unit Layout ABC DEF GHI JKL MNO Pqrs TUV Wxyz Tone OperSetup Data PortInstallation of Battery Pack in Handset Charging Of Handset Battery Pack Charging Of Handset Battery PackTone/Pulse selection Dial ToneChecking for dial tone Case of DifficultySpare Battery Charger/Power Backup Function Setup Of The VT20-2420 Accessory Handset Registration and OperationHandset Charger Enter Base ID Code Handset and Base Indicators Handset IconsIcon Description Handset LEDs DescriptionBase LEDs Soft Menu Functions RDL RedialCall History Caller ID Call History Caller ID Caller ID Call Waiting IDHistory Dial Option Shortcut Volume Use Handset and Base SettingsSETTINGS, then press OK Melody UseLOW Batt Tone To select the Enhanced Mode setting Naming Your HandsetsHandset and Base Settings Register To Deregister all HandsetsMemory MemoryTo Store a Number/Name To Search For and Dial a Number Name To Delete a Number/NameTo Edit a Number/Name From the Handset Handset and Base OperationMaking Calls From the Base UnitRedial Answering CallsFrom either Handset or Base Unit Mute Function Flash Function Hold FunctionFrom the Base Volume Intercom FunctionBlind Transfer Transferring CallsHandsfree Speakerphone Operation Announced TransferBase Speakerphone Operation Switching from the Handset Earpiece to HandsfreeLow Battery Indication Line in Use IndicationMessage Waiting Indication Conference CallingLine Conference Calls Handset or Base Headset Operation connected to the Handset To purchase a Headset, call Vtech Customer Service atHeadset Operation Headset Operation connected toMaintenance Phone Doesnt Work At All Handset Does Not Ring When You Receive a CallCase Of Difficulty No Dial ToneYou Hear Other Calls While Using Your Phone Common Cure For Electronic EquipmentHow long is the limited warranty period ? Warranty StatementWhat does this limited warranty cover? What is not covered by this limited warranty ?How do you get warranty service? Other LimitationsWarranty Statement FCC and IC Regulations VTech Communications IncFCC and Acta Information Repair instructionsRights of the telephone company Programming/testing of emergency numbers IC Industry CanadaHearing aid compatibility Rbrc R Seal Technical Specifications Nominal Effective RangeTable Of Contents Issue
Top Page Image Contents