Avaya 4600 manual Self-Test Procedure, Hold 8 3 7 8 # Hold T E S T #, Self test #=end

Local Administrative Options

If you press the # button, the following text is displayed left-justified at the top of the display while the system values are reset to defaults:

Resetting values.

Once the system values are reset, the following prompt is displayed:

Restart phone?

*=no #=yes

3.Press the * key to terminate the procedure without restarting the telephone. Press the # key to restart the telephone.

The remainder of the procedure depends on the status of the boot and application files. Refer to Appendix A.

Self-Test Procedure

To invoke 4600 Series IP Telephone self-test procedures, press the following sequence of keys on the faceplate of the telephone:

Hold 8 3 7 8 # (Hold T E S T #)

The telephone illuminates each column of red and green LEDs associated with administrable buttons sequentially for 0.5 second, from left to right across the telephone, in a repeating cycle. The Speaker/Mute LED and the message waiting LED are illuminated along with the closest column of LEDs. Buttons generate a button click if pressed, but do not generate any system- specific signaling messages, DTMF, or invoke speakerphone or mute operation.

Telephones with displays display the following text, left-justified at the top of the display, for 1 second after self-test is invoked:

Self test #=end

Then a block character (all pixels on) is displayed in all display character locations for 5 seconds. Display of the block character is used to find bad display pixels.

One of the following is displayed:

If self-test passes:	Self	test passed
	#=end
If self-test fails:	Self	test failed
	#=end

4.To terminate the self-test, generate confirmation tone, and return the user interface to the previous state, press the # button on the dial pad at any time.

Static Addressing Installation

3-9