Begin on Channel 1 (do not click on the Edit option), configure the “Port Type” to “Trunk”, then set the “Trunk Group” to match the trunk group name you created and define a “Description” (the “Description” is a label and can be anything, but you should define something that is useful and will allow you to determine which channel is being utilized), then click on the “Fill Down” radio button. This action will automatically populate all of the remaining channels. Finally, be sure to “Save” all of the changes. This completes all the configuration modifications necessary on the ShoreTel system.
ADTRAN Configuration
To get started with the ADTRAN device configuration, refer to the Quick Start Guide and ADTRAN Operating System (AOS) and documentation CD included in the product box with each device. Quick Start Guides may also be downloaded from the ADTRAN support Web site at www.adtran.com/support by searching on the product device name. Once the ADTRAN device is unpacked and powered on, ADTRAN Total Access platforms can be configured via a
Initial configuration will be via the CRAFT port, where you‟ll define an IP address on ETH 0/1, the remaining configuration will be via the Web interface GUI. Connect to the CRAFT port with the following com port settings, using your preferred terminal emulation application (i.e. Tera Term Pro, Putty, HyperTerm, etc.).
Com Port
Username and Passwords are all set to adtran.
Once you have successfully logged in, perform the following actions:
CONFIGURE THE UNIT’S IP ADDRESS
1.At the # prompt, enter config terminal.
2.At the (config)# prompt, enter interface eth 0/1 to access the configuration parameters for the
960 Stewart Drive Sunnyvale, CA 94085 USA Phone +1.408.331.3300 +1.877.80SHORE Fax +1.408.331.3333 www.ShoreTel.com
- 11 -