AT&T CL81219, CL81209 user manual To register a handset to your telephone base

Appendix C

Expansion handset

Adding and registering handsets (optional)

Handsets purchased separately (AT&T CL80109) need to

be registered to the telephone base before use. When first	NOT REGISTERED
purchased, all expansion handsets show NOT REGISTERED on
the screen. New handsets may need to be charged without
interruption for at least 30 minutes before registering to the
telephone base.
To register a handset to your telephone base
1. Make sure the handset is out of the telephone base or
charger and shows NOT REGISTERED before you begin	NOT REGISTERED
registration.
2. Press and hold HANDSET LOCATOR on the telephone
base for about four seconds (until the red IN USE light on
the telephone base is on) and then release the button. The	PRESS HNDST LOC
IN USE light remains on while the telephone base attempts	4 SEC ON BASE
to register a handset.
3. Place the unregistered handset into the telephone base or
charger, PRESS HNDST LOC 4 SEC ON BASE shows on the	PLEASE WAIT...
handset screen. The handset is now registering with the
telephone base. The handset then shows PLEASE WAIT...
and it takes up to 60 seconds to complete the registration.
There is a beep sound when the registration is successful.
The handset shows HANDSET X REGISTERED, with X being	HANDSET X
the handset number (1-12).
	REGISTERED

NOTES:

1.If the registration is not successful, the screen shows NOT REGISTERED. To reset the handset, remove the handset from the telephone base or charger, then start again from step 2 above.

2.You cannot register a handset if any other system handset is in use.

40