AT&T E1113B user manual Changing feature options, To set selection

1.	SETUP
	until desired feature
	is heard (see list at
	right).

Answering system operation

Changing feature options

You can change how the answering system oper- ates. Press SETUP repeatedly to hear each feature. When you hear the feature you want to modify press SKIP or REPEAT to change the setting.

Feature options (default settings underlined).

System announces: Feature description:

2.	SKIP or
	REPEAT

until desired selection is heard.

3.	SETUP
	to set selection and
	move to next menu

"Number of rings", current setting, then "To change the setting press SKIP or REPEAT; to continue setup, press SETUP." Options: 2/4/6/toll saver

Choose number of rings before the sys- tem answers a call. When toll saver is active, the system answers after two rings if you have new messages, and after four rings if you have no new messages. When retrieving messages from a long distance call, you may disconnect your call after three rings so that there will be no long distance charge incurred.

option.

- OR -

PLAY/STOP

“Base ringer”, cur- rent setting, then “To change the setting press SKIP or REPEAT; to continue setup, press SETUP.” Options: high/low/off

Choose telephone base ringer volume to high or low level, or turn the tel- ephone base ringer off.

to set selection and exit menu.

NOTES:

1. The message alert tone will

beep only if all the conditions

below are met:

Answering system is on

Message alert tone setting is

"Remote access code", current setting, then "To change the setting press SKIP or REPEAT; to continue setup, press SETUP" Options: (select two- digit code) 19

Select a two-digit number (10-99) for remote access from another tel- ephone (page 39).

NOTE: Press and hold SKIP or

REPEAT to increase or decrease the remote access code number by 10.

on

Have new messages

2. Press any base key (except

RECORD, ANSWER ON

and HANDSET LOCATOR)

to temporarily silence the mes-

sage alert tone. If you press

and hold DELETE you will

delete all old messages and

the message alert tone will be

temporarily silenced. The mes-

sage alert tone will be re-acti-

vated with the next incoming

message.

"Message alert tone," current setting, then "To change the setting press SKIP or REPEAT; to continue setup, press SETUP." Options: on/off

When on, the telephone beeps every 10 seconds when there are new mes- sages.

37