Getting Started
Telephone base installation
Install the speakerphone base as shown below. Choose a location away from electron- ic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Getting Started
Battery installation & charging
After installation, place the handset in the base and allow the battery to charge for 12 hours before use. You can keep the battery charged by returning the handset to the base after each use. When battery power is fully depleted, a full recharge takes about 8 hours.
NEW 00 | OLD 27 |
0 | 8/12 10:06 AM |
NOTE: Use only the power cord supplied with this product.
If you need a replacement,call 1 800
Be sure to use an electrical outlet not controlled by a wall switch.
Plug power cord transformer into electrical outlet
Plug long line cord into telephone jack
Low battery indicator
Return handset to base to recharge when this symbol appears. (Handset will beep when battery is low.)
Press tab to open battery compartment
Plug in battery here
Insert battery and replace compartment cover
Place handset in base to charge for 12 hours before first use.
Charging light will be illuminated while battery is charging.
Rotate antenna to fully upright position
7