Wall mounting, Belt clip & optional headset

Getting Started

Wall mounting

The speakerphone base can be installed on any standard wall-phone outlet as shown below. Choose a location away from electronic equipment, such as personal comput- ers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.

Getting Started

Belt clip & optional headset

Install belt clip as shown below if desired.

For hands-free telephone conversations, you can use any industry standard 2.5 mm headset (purchased separately). For best results use an AT&T 2.5 mm headset.

Plug power cord transformer into electrical outlet

Press and slide down firmly so base is held securely on outlet mounting pegs

Rotate cradle up to hold handset upright

1 Use a flat-head screwdriver or coin to turn the screw head to the unlock position.

2 Rotate cradle up to hold the handset upright when wall mounted.

3Use a flat-head screwdriver or coin to turn the screw head to the lock position.

Plug short line cord into telephone jack

Rotate antenna to fully upright position

Snap belt clip into notches on side of handset. Rotate and pull to remove.

Plug 2.5 mm headset into jack on side of handset (beneath small rubber cap)