Spectrum Brands SP-400 manual FCC Part 15 Compliance

Page 5

FCC Part 15 Compliance

Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

[ The term “IC:” before the certification/registration number only signifies that the Industry Canada technical specifications were met. ]

Canadian Emissions Compliance

"This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. "

"Le present appareil numerique n'emet pas de bruits radiolectriques depassant les limites applicables auix appareils numeriques de la class B prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada."

5

Image 5
Contents Page This page is intentionally left blank Page Important Safety Instructions FCC Part 15 Compliance DOC Notice and Load Number Statement Consumer Information Page Page TOP Panel Page Right Side Left Side Rear Page Parts Check List Power Outlet Configuration Connector Configuration 120V AC Outlet Recovery Power Adapter providedPower Adapter Line Connection Power Adapter Phone ConnectionInstalling The Wall Power Adapter optional Directory Index Card Installing the Keycaps Connecting the Handset CordDesk Mounting Wall Mounting the SpectrumPLUSTM TelephoneMessage Waiting Light Indicator System Hold Feature Option Switch Programming The Flash Timing Using a Flash When DialingProgramming Flash Timing into Memory Programming Example for 100mS Programming Flash TimingProgramming Pause Into Speed Dial Using a Pause When DialingProgramming a Pause into Memory Programming Procedure Installing a Headset Headset FeaturePlacing/Answering a Call Using the Headset On/Off Feature Using a HeadsetSpeaker Line Indicators In-Use IndicatorsHold Key Indicators Headset Key IndicatorsPlacing a Call Using Speakerphone Using the Data Port Using the Hold Feature Using The Mute Feature Using the Redial Feature Using The Disconnect Feature Key Handset Volume Control Page Page To Place An Order Parts ListStatement of Limited Warranty