Analog Devices 82-000218-01 manual TWI Flash Address Configuration Jumper JP1

Page 28

Jumpers

TWI Flash Address Configuration Jumper (JP1)

The TWI flash address configuration jumper (JP1) controls the base address of the configuration flash memory. When multiple EZ-Extenders are stacked on top of each other, it may be necessary to change the JP1 set- ting to avoid any conflict with the configuration flash memory on another EZ-Extender. The default is no jumper installed.

TWI Flash Write Protect Jumper (JP2)

The TWI flash write protect jumper (JP2) is not available; the jumper is intended for internal Analog Devices test purposes only. The default is no jumper installed.

Soft Reset Configuration Jumpers (JP3–4)

The software reset configuration jumpers (JP3—4) determine which GPIO signal is used to perform a soft reset of the Bluegiga WT12 Bluetooth module. The default is no jumpers installed.

Bluetooth Module Default Configuration Jumper (JP5)

The Bluegiga WT12 Bluetooth module default configuration jumper (JP5) resets the module’s settings to the default values. This feature requires software support; refer to the example programs for more infor- mation. The default is no jumper installed.

UART Receive Data Jumper (JP6)

The UART receive data jumper (JP6) is not available; the jumper is intended for internal Analog Devices test purposes only. The default is no jumper installed.

2-6

Bluetooth EZ-Extender Manual

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Bluetooth EZ-ExtenderManual Copyright Information Trademark and Service Mark NoticeDisclaimer Regulatory Compliance Page Contents Bluetooth EZ-EXTENDER Hardware Reference Index Viii Bluetooth EZ-Extender Manual Preface Product Overview Purpose of This Manual Manual ContentsIntended Audience What’s New in This Manual Technical or Customer SupportSupported Products Product InformationAnalog Devices Web Site Technical Library CDRelated Documents Title DescriptionNotation Conventions Example DescriptionUsing Bluetooth EZ-EXTENDER Package Contents Bluetooth EZ-Extender Default Configuration Flash Memory Interface Bluetooth EZ-Extender SetupUart Interface Bluetooth Module USB InterfaceExpansion Interface Example ProgramsBluetooth EZ-EXTENDER Hardware Reference System Architecture onSystem Architecture Configuration Switch Bluetooth EZ-Extender Hardware ReferenceConfiguration Switch Jumper Locations Bluetooth EZ-Extender Manual JumpersTWI Flash Address Configuration Jumper JP1 Soft Reset Configuration Jumpers JP3-4Bluetooth Module Default Configuration Jumper JP5 TWI Flash Write Protect Jumper JP2Power LED Power LED Location Bluetooth EZ-Extender ManualConnectors Connector Locations Bluetooth EZ-Extender ManualStamp Uart Connector J1 Expansion Interface II Connector J3Expansion Interface II Connector J5 Expansion Interface II Connector P2Expansion Interface II Connector P4 USB Connector P3Connectors Bluetooth EZ-EXTENDER Bill of Materials IDC 4X2 IDC4X2 JP3 Sullins GEC04DAAN Bluetooth Daughterboard Bluetooth EZ-EXTENDER Bluetooth EZ-EXTENDER LS Connector Analog Devices Index Index
Top Page Image Contents