Bluetooth EZ-Extender Hardware Reference
STAMP UART Connector (J1)
The STAMP UART connector (J1) allows the Bluetooth EZ-Extender to be plugged onto an EZ-KIT Lite development board supporting a STAMP interface. The J1 connector is located on the bottom side of the board. For availability and pricing of the connectors, contact Samtec.
Refer to “Expansion Interface” on page 1-6 or more information.
Part Description | Manufacturer | Part Number |
| | |
| | |
10-position 0.1”, SMT socket | SAMTEC | SSW-105-22-F-D-VS |
| | |
| Mating Connector | |
| | |
10-position 0.1’’, SMT header | SAMTEC TSSH | TSSH-105-01-L-DV-A |
| | |
Expansion Interface II Connector (J3)
The board-to-board connector (J3) provides signals for the SPI, TWI, UART, SPORT interfaces and general-purpose I/O (GPIO) signals of the mating EZ-Board. The connector is located on the bottom side of the board. For availability and pricing of the connectors, contact Samtec.
Refer to “Expansion Interface” on page 1-6 for more information.
Part Description | Manufacturer | Part Number |
| | |
| | |
50-position 0.1’’, SMT socket | SAMTEC | SSW-125-22-F-D-VS |
| | |
| Mating Connector | |
| | |
50-position 0.1’’, SMT header | SAMTEC | TSSH-125-01-L-DV-A |
| | |
Bluetooth EZ-Extender Manual | 2-9 |