Nortel Networks ICS 6.1 Protocol PrivNetId Discon timer, Answer timer, CO fail, Levels, Framing

103

•••• Protocol

•••• PrivNetId

••• Discon timer	Specify the duration of an Open Switch Interval for a Trunk Cartridge.
••• Answer timer	Select the minimum duration, in seconds, of an answer signal before a call is
	considered to be answered, for an E&M trunk cartridge.
•• CO fail	Select the carrier failure standard used by your T1 service provider.
	This setting only appears for DTIs.
•• I/F levels	Interface levels defaults to the ISDN loss plan setting.
	Check with your telecommunications service provider to find out the I/F level
	of your connection:
	• digital network loss treatment (ISDN I/F levels)
	• analog network loss treatment (PSTN I/F levels)
•• Framing	Use to select the framing format used by your T1 service provider.
	This setting only appears for DTIs.
•• Internal CSU	Use to turn the internal TI channel service on or off.
	The channel service unit gathers performance statistics for your T1 lines.
•• CSU line bld	Use to set the gain level of the transmitted signal.
	This setting only appears for DTIs that have their internal CSU turned on.
•• DSX1 bld	Use to set the distance between the ICS and an external channel service unit.
	This setting only appears for DTIs that have their internal CSU set to Off.
•• Line coding	Select the standard used by your T1 service provider for encoding signals on
	the T1 lines.
•• ClockSrc	Determine the type of clock source.
••• Loops	View the loops on a BRI Card.
••• Loop nnn	View the settings for a particular loop on a BRI Card.
•••• Type	View or change the loop type.
•••• Sampling	Select the sampling used by an S-loop.
•••• DNs on Loop	Assign the ISDN DNs that use this loop.
••••• Assign DNs	Enter ISDN DNs for each S-loop or LT loop.
••••• Show DN:_	Indicate whether or not the DN is assigned to a loop.
••••• Loop DN:_	Select the main ISDN DN, if any, for the loop.
••• SPID1	Enter the SPID supplied by your service provider.
••• # of B-channls	Select the number of B-channels that are associated with the SPID.
••• Network DNs	Enter the Network DNs that are associated with the SPID.
	A Network ISDN DN can be assigned to more than one SPID.
•••• Call type	Select the Call type used with the Network DN.
	For each ISDN DN, use only one of each of the Voice and Data call type
	settings, or a single Both call type setting.

P0603536 02 Modular ICS 6.1 Programming Record