Nortel Networks ICS 6.1 Auto privacy, Trunk mode, Ans mode, Ans with Disa, Link time, Link at CO

89

••• Auto privacy	Select whether a line will be private to the individual on a call, or whether it
	can be shared by other users while a call is in progress. The Privacy setting
	can be suspended for individual calls using the privacy feature (		).
••• Trunk mode	Select whether the line operates with disconnect supervision. Auto answer
	and DISA lines must be supervised. This setting does not appear for target
	lines.
••• Ans mode	Select whether the line will be answered manually, the normal call answering
	method, or automatically by the system. Auto answer allows remote access
	to your Norstar system. This setting only appears if Trunk mode is
	supervised.
••• Ans with DISA	Select whether a line programmed for auto answer will be answered with
	Direct Inward System Access (DISA) or with system dial tone. This setting
	only appears if Ans mode is Auto. This setting does not appear for target
	lines.
••• Link time	Select the duration of a signal, such as recall or flash, when a signal is
	required to access a feature through a remote system.
••• Link at CO	Select whether the system applies the restrictions on outgoing calls to the
	digits dialed after the Link signal (a host signalling option).
••• Aux. ringer	Select whether an auxiliary ringer, if installed, will ring for incoming calls on
	this specific line.	￿°‹
••• Full AutoHold	Select whether an idle line will be put on hold when another line is selected.
	This setting does not appear for target lines.
••• Distinct Ring	Choose whether the line will have a distinctive ring pattern.
••• LossPkg	Select the appropriate loss/gain and impedance package for analog loop
	lines only. Select the package based on the terminating switch type (PBX or
	CO), and the distance from the switch (Short, Medium or Long). This setting
	only appears if Cd1-KSU is Loop. It does not appear for target lines.
••• Rec’d #	Enter the Received number for this target line. When the system
	automatically answers an incoming call on auto-answer Loopstart or digital
	lines:
	• it collects the number of digits specified by the Rec’d # length setting
	• it matches these digits to a Received number
	• it routes the call to the appropriate target line.
	A Received number cannot be the same as, or be the start digits, of a line pool
	access code, a destination code, the DISA DN, or the Auto DN.
••• Signal	Select the signal type for an E&M or DID line to match the signal type
	programmed for the trunk at the other switch.
••• ANI number	Select whether the telephone number of the caller will be collected for this
	E&M or DID line. The digits can then be displayed on Norstar telephones as
	part of Call Information services.
••• DNIS number	Select whether the digits dialed by an external caller on this E&M or DID line
	will be collected.
••• Gain	Select the appropriate gain level for this E&M or DID line.
•• Name	Enter a name for a line that is up to seven characters long. This name defaults
	to the line number.
•• Restrictions	Allows you to create and assign restriction filters. These filters control what
	kind of calls a user can make on this line.

P0603536 02 Modular ICS 6.1 Programming Record