Nortel Networks ICS 6.1 manual Glossary of programming headings and settings, Dialpad, Startup

81

Glossary of programming headings and settings

This section presents the programming hierarchy in the Norstar Modular ICS/Modular ICS-XC interface. The dots each represent a

level below the top level

				Below the
				3rd level
				••••
				•••••
Top Level	Level 1	Level 2	Level 3	••••••
	•	••	•••	•••••••

Menu item	Description
Profile	Change on non-North American systems, only!
(use only at system startup)	Use this command to choose a profile that reflects the trunk card profile for
	the specific country.
	Use Profile password.
	WARNING: Never use this command after Startup has been run.
Dialpad	Use this command to select the dialpad layout you require. This is a system-
(use only at system startup)	wide setting.
	Use Dialpad access.
Startup	Use this command to select the default information specific to your system.
(use only for initial configuration at system startup)	Use Startup access.
	This command is only available immediately after startup of the KSU.
• Template	Select the template to assign the default values for the system.
• Start DN	Enter between three and seven digits to indicate the first DN of the range you
	plan to use.
	The length of this entry also defines the default DN length and the default
	Received number length.
	Note: If the first digit of a DN is the same as any of the follow codes, the
	system sets these codes to None:
	• Direct-dial digit
	• Call Park prefix
	• first digit of a line pool access code

P0603536 02 Modular ICS 6.1 Programming Record