Nortel Networks ICS 6.1 VMsg ctr tel#s, VMsg center Use line routing tbl, Tel#, ONN blocking

102

Telco features	These commands allow you to assign settings for external voice messaging
	services.
• VMsg ctr tel#s	These commands allow you to determine which voice message center the set
	will use, and how it will access the network.
•• VMsg center 1	Choose the voice message center you want the set to use.
•• VMsg center 2
•• VMsg center 3
•• VMsg center 4
•• VMsg center 5
••• Use: line routing tbl	Select whether the set will access the voice message center over a direct line,
	or through a routing table.
•••• Tel#	Enter up to a 24-number telephone number that accesses the voice
	messaging center.
• ONN blocking	Allows outgoing name and number to be blocked at the called party end on
	both analog and digital lines.
•• Analog VSC	Analog Vertical service code.
••• Tone	Vertical service code for analog tone dialing trunks.
••• Pulse	Vertical service code for analog pulse dialing trunks.
•• BRI VSC	Basic Rate Interface Vertical service code.
••• Code:	Enter the BRI code.
Software keys	These commands allow you to set up access to optional features and
	services through Nortel Networks programming.
• SysID	This number can be viewed on any M7324, M7310, T7316 or T7316E display.
	Record the number. You will be asked to provide this number when you call
	the Nortel Customer Response Center.
• Password keys	Keys are required for some system expansion activities and to activate the
	remote monitoring capability. To obtain the required keys for ISDN PRI, and
	fixed access trunks/WAN access for Data Modules, call the Nortel Customer
	Response Center at: 1-800-684-5825.
	Note: An ISDN PRI key is required for MCDN networking.
•• Key 1	Enter the eight-digit password.
•• Key 2	Enter the eight-digit password.
•• Key 3	Enter the eight-digit password.
Hardware	Use these commands to view and configure the Trunk Cartridges and BRI
	Cards installed in the ICS.
• Show module:_	Indicate the module you wish to view.
• Cards on KSU	View and program the cartridges and cards installed in the ICS.
•• Cd1-KSU	View the type of card that occupies the right-most slot in the ICS.
••• Card type	The display shows the current card type.
••• Lines	View the line-number range for the lines on a Trunk Cartridge.
••• Show lines ___

Modular ICS 6.1 Programming Record P0603536 02