Nortel Networks ICS 6.1 DND on Busy, Handsfree, HF answerback, Pickup grp, Zone, Paging, Dial

							83
••• DND on Busy	Select whether or not an incoming call rings if the user already is on another
	call.
••• Handsfree	Select whether handsfree will be available to a telephone.
••• HF answerback	Select whether a user can automatically answer a voice call without lifting the
	receiver or pressing the			button. It is always turned off for a T7100
	telephone.
••• Pickup grp	Any user in a pickup group can answer calls to any other telephone in their
	group using the Call Pickup-group feature (						). Choose one of nine
	pickup groups, or choose None to disable the feature for this telephone.
••• Page zone	Assign a page zone to allow this set to receive pages, or choose None to
	prevent pages at this telephone.
••• Paging	Select whether paging can be performed from this Norstar telephone.
••• D-Dial	Select whether you can call the Direct-dial telephone from this telephone
	using the Direct-dial digit.
••• Priority call	If a call is critical for the called party to receive, you can program this
	telephone to interrupt calls or to override Do Not Disturb at another Norstar
	telephone when you enter				.
	A priority call can be refused at the set you call if the called party enters Do
	Not Disturb (		).
	However, a priority call cannot be blocked by at a telephone that is already in
	Do Not Disturb mode.
••• Hotline	Select whether a telephone number will be dialed automatically when a user
			￿
	lifts the receiver or presses the button on the memory keys that is designated
	as the handsfree/mute button.
•••• Intrnl#:None	Choose Intrnl to enter an internal Norstar telephone as the hotline.
						￿‡fi
••••• Intrnl#:_______	Enter the internal DN you want to use as the hotline.
•••• Extrnl#:None	Choose Extrnl to enter an external telephone as the hotline.
••••• Extrnl#:_______	Enter the external DN you want to use as the hotline.
••• Aux. ringer	Select whether an external auxiliary ringer will ring for incoming calls at this
	telephone.
	Note: The customer-supplied ringer hardware must be installed before the
	feature will work.
	￿fl·
••• Allow redirect	Select whether to allow this telephone to redirect lines.
••• Redirect ring	Select whether a telephone rings briefly when a call is redirected by the Line
		￿°fi		).
	Redirection feature (
••• ATA settings	Analog telephones or other devices which are connected to the ICS using an
	Analog Terminal Adapter (ATA) may need the additional programming found
	under this subheading.
•••• ATA ans timer	This setting determines the timing between when an ATA-connected device
	dials out and when the device becomes ready to receive DTMF tone from the
	far end analog device.
•••• ATA use	Choose the setting that indicates where the ATA is situated (On Site/Off Site)
•••• MsgIndicate	Select the type of message indicator the ATA-connected device provides.
	(None, Tone, Lamp).￿°›
P0603536 02							Modular ICS 6.1 Programming Record