Nortel Networks MOG7xx, MOG6xx manual Dhcp options, Option Meaning

Page 32

32

The IP-related parameters of the WLAN Handsets 2210/2211 can be configured manually or through a DHCP Server (RFC 1541 and RFC 1533). The DHCP Server can be on either side of the firewall, according to the site administrator’s preference. The DHCP Server is optional if the WLAN handsets and WLAN IP Telephony Manager 2245 are statically configured.

Each wireless handset effectively uses two IP addresses in the wireless subnet. One is for the physical set, and one is the second alias IP address that is used on the WLAN IP Telephony Manager 2245 Server. A contiguous block of addresses, equal to the number of handsets supported, must be marked as unavailable for distribution when you allocate addresses in a subnet scope on the DHCP Server.

The DHCP Server can require specific configuration modifications when multiple WLANs are connected to a single Wireless Security Switch (WSS). Refer to the documentation that accompanies the specific WSS being used for any special DHCP configuration requirements.

The WLAN handset searches for server configuration in the options listed in Table 1. The wireless handset uses the DHCP options listed when DHCP use is enabled.

Table 1

DHCP options

 

 

 

Option

 

Meaning

 

 

 

1

 

Subnet mask

 

 

 

3

 

Default Gateway

 

 

 

6

 

DNS Server

 

 

 

15

 

Domain name

 

 

 

66

 

TFTP Server

 

 

 

128

 

Site specific

 

 

 

151

 

WLAN IP Telephony Manager 2245

 

 

 

191

 

Site specific

 

 

 

siaddr

 

Boot server or next server

 

 

 

When the patch is applied to Release 3.6, or when Release 3.7 or later is running, two new fields appear under Global options:

DHCP Option 66 - This can be used to specify the address of the TFTP Server. If this Option is not present the phone will look at the Next server/ Boot server (siaddr) option for the address of the TFTP server.

Vendor Specific Option 43, 128, 144, 157, 191, or 251 - Only one of these options is required. The DHCP Server encodes the Server 1 information using the same format as the IP Phone 2004. If the Server 2 information is also present in the option, it is ignored.

DHCP Option 151 - This option contains the IP address of the WLAN IP Telephony Manager 2245. If Option 151 is not configured, the wireless handset performs a Domain Name Service (DNS) lookup of the name “SLNKSVP2”, if Options 6 (DNS Server) and 15 (Domain Name) are configured.

Overview

Image 32
Contents Part No. N0008588 September 17 Safety North American Regulatory InformationCopyright 2004 Nortel Networks TrademarksRadio-frequency Interference Enhanced 911 ConfigurationInstallation and Configuration Guide Repairs Important Safety InstructionsHearing Aid Compatibility Installation and Configuration Guide International Regulatory Information Limited Warranty ExclusionsWarranty Repair Services After Warranty ServiceContents Wlan IP Telephony Manager 2245 installation ContentsAppendix a Compatible Access Points Appendix C Testing the Wlan Handsets 2210/2211 Figures Contents Installation and Configuration Guide Tables Contents Installation and Configuration Guide Preface Before you beginPreface Symbols used in this guideText conventions Nortel Networks Wlan Handsets 2210/2211 IP telephonesAcronyms used in this guide CTE FTP Mlppp RPC Related publications Preface N0008588 How to get help How to get help Network configuration OverviewDescription OverviewBasic network configuration Tftp ServerWlan Handset 2210/2211 firmware upgrade Dhcp ServerDhcp options Option MeaningFirewall Wlan IP Telephony ManagerPhysical description Wlan IP Telephony Manager 2245 front panelFunctional description Wlan IP Telephony Manager 2245 firmware upgrade CapacitiesAPs on the same subnet APs on different subnets using WSSRoaming and handover Roaming and handover capabilities summary Access PointMobility across different subnets when using Dhcp Network planning IP address planningProgramming Records IP addressing with DhcpWlan IP Telephony Manager 2245 installation Preparing to install the Wlan IP Telephony ManagerWlan IP Telephony Manager 2245 installation Required materialsWall-mounting the Wlan IP Telephony Manager Pre-installation checklistMounting the Wlan IP Telephony Manager Connecting to the LAN Connecting the powerRemoving a Wlan IP Telephony Manager Rack-mounting the Wlan IP Telephony ManagerWlan IP Telephony Manager 2245 installation Wlan IP Telephony Manager 2245 configuration Connecting to the Wlan IP Telephony ManagerConnecting through a serial port Wlan IP Telephony Manager 2245 configurationConnecting through a Telnet session Configuring the Wlan IP Telephony Manager NetLink SVP-II System menuConfiguring the network Network Configuration screenWlan IP Telephony Manager 2245 configuration Configuring the SVP-II SVP-II Configuration screenWlan IP Telephony Manager 2245 configuration Changing the password Change Password screenSaving the configuration SVP-Configuration screen with reset promptTelnet screen after reset Checking the system statusWlan Handsets 2210/2211 Wlan Handsets 2210/2211 configurationWlan Handsets 2210/2211 configuration Wired Equivalent Privacy Loss of signalWlan Handsets 2210/2211 functions LanguageFeature and key assignment CodecsJitter buffer RTP and RtcpIP Phone Wlan Handsets 2210/2211 configuration Wlan Handset Configuring the Wlan Handsets 2210/2211 IP Phone 2004 mapping to the wireless handsetsKeys to enter non-numeric characters Sheet 1 Opening and using the Admin MenuMaking an alphanumeric string entry Keys to enter non-numeric characters Sheet 2 Admin Menu optionsAdmin Menu options Sheet 1 Admin Menu options Sheet 2 IP Address menuWlan Handsets 2210/2211 configuration Essid License ManagementRestore Defaults Site Survey modeRegulatory Domain SecurityTerminal type OAI on/off Admin PWDownloading the Wlan handset firmware Pre-download checklist Downloading the firmwareProgramming the Line keys Configuring the idle state displayProgramming the Wlan Handsets 2210/2211 Troubleshooting Troubleshooting the Wlan IP Telephony ManagerError Status screen TroubleshootingWlan IP Telephony Manager 2245 active alarms and actions Network Status screenNetwork Status screen Software Version Numbers screen Software Version Numbers screenFeature limitations Duplex mismatchSyslog Server Appendix a Compatible Access Points Appendix a Compatible Access PointsIntroduction SVP-compliant APs Sheet 1SVP-compliant APs Sheet 2 Appendix B Wlan Application Gateway Wlan Application GatewayModel numbers with maximum number of users Appendix B Wlan Application GatewayInstallation Model MOG6xxPreparing to install the Wlan Application Gateway Rack-mounting the Wlan Application Gateway Mounting the Wlan Application GatewayWall-mounting the Wlan Application Gateway Connecting to the Application Server Connecting through the LANConnecting through an RS-232 port Pins on the connectorConnect through a modem Wlan Application Gateway 2246 connection through a modemConfiguration Connecting to the Wlan Application Gateway04830130 Configuring the Wlan Application Gateway NetLink OAI System menuConfiguring the OAI Box OAI Box Configuration screenAllow FTP Connections Yes/No MOG 7xx only Continuing configuration through Telnet Connecting through TelnetPage Configuring the Telephone Line Telephone Line configurationDeleting a Wlan Handset 2210 or Searching for a Wlan Handset 2210/2211Programming a feature Setting or changing a password Feature programming screenChange password Viewing system statusViewing network status Network Status Viewing Telephone Line Status Telephone Line Status screenWlan Application Gateway 2246 certification Certification testingViewing software versions Wireless handset certification Software updates on MOG700 systemsUpdating software Software filesObtain software using FTP Tftp software updates for MOG600 Systems 105 Planning Worksheet for Wlan Handsets 2210/2211 Wlan Handset 2210/2211 Planning WorksheetFreeing the serial port for administrative purposes 108 Appendix C Testing the Wlan Handsets 2210/2211 Testing calls and featuresTesting signal strength with the Wlan handsets Appendix C Testing the Wlan Handsets 2210/2211110 111 112 Site Survey mode Appendix D ProvisioningSite survey Site certificationConducting an effective site survey Network usageMobility requirements Physical site studyRF transmission testing Example of AP placement116 Solving coverage issues Solving overlap issues118 Index BCMIndex

MOG6xx, MOG7xx specifications

Nortel Networks was a prominent player in the telecommunications industry, known for its innovative products and solutions. Among its offerings are the MOG6xx and MOG7xx series of voice over IP (VoIP) gateways, designed to enhance and facilitate voice communications over data networks.

The MOG6xx series, which includes models like MOG660 and MOG670, was introduced to serve as a bridge between traditional telephony and modern IP-based networks. These gateways feature advanced signaling and media capabilities that make them an essential tool for businesses looking to migrate to IP telephony. The MOG6xx series supports a wide range of protocols, including SIP, H.323, and MGCP, ensuring interoperability with various systems and devices.

One of the key characteristics of the MOG6xx series is its scalability. These gateways offer flexible capacity options that allow organizations to start with a smaller investment and expand as their communication needs grow. Additionally, the MOG6xx series is designed to support numerous simultaneous calls, ensuring that businesses can operate efficiently even during peak usage times.

The MOG7xx series, including the MOG770 and MOG730 models, builds upon the foundational technologies of the MOG6xx with enhanced features and capabilities. The MOG7xx series focuses on providing higher capacity and advanced functionalities, making it particularly suitable for larger enterprises or service providers. Key features include improved echo cancellation, advanced call routing, and enhanced security protocols to protect voice data from unauthorized access.

Both the MOG6xx and MOG7xx series leverage Nortel's expertise in voice quality assurance through integrated voice processing technologies. This ensures that calls maintain high audio quality, crucial for effective communication. Additionally, these gateways support various codecs to accommodate different network conditions, further enhancing their versatility.

In terms of management, both series are equipped with user-friendly interfaces and robust diagnostic tools that enable administrators to efficiently monitor and manage voice traffic. This not only simplifies troubleshooting but also assists in optimizing network performance.

Overall, the Nortel MOG6xx and MOG7xx series provide reliable, scalable, and flexible solutions for organizations looking to integrate voice communications with their data networks. Their support for industry-standard protocols, commitment to voice quality, and advanced feature set make them standout options in the increasingly competitive landscape of VoIP gateways.