Installing the CallPilot 100/150 5
Mounting the CallPilot 100/150 on the wall
1Attach the wall mount bracket to a secure surface by the two inner holes. Use anchors, as necessary.
2Slip the slot on the back (near the top) of the CallPilot 100/150 onto the bracket.
3Secure the CallPilot 100/150 using a screw in the lower screw hole.
Note: If you are upgrading from a previous voice messaging system (for example, FlashTalk) to CallPilot 100/150, you must remove the existing Feature Codes for the old voice messaging system before you install the CallPilot 100/150. For information about how to remove the existing Feature Codes, refer to CallPilot 150 Feature Codes are inactive, in the CallPilot 100/150 Installation and Maintenance Guide.
Connecting the CallPilot 100/150
1Open the CallPilot 100/150 by inserting a flat screwdriver into the slot on the
2Connect a TCM cable to Port A and to Port B. Table 2 shows the pin out of Port A and Port B.
Table 2 Port A and Port B Pinouts
| CallPilot 100 | CallPilot 150 | ||
|
|
|
|
|
Pin number | Port A | Port B | Port A | Port B |
|
|
|
|
|
1 | no connection | no connection | no connection | no connection |
|
|
|
|
|
2 | no connection | no connection | TCM 3 | TCM 4 |
|
|
|
|
|
3 | TCM 1 | TCM 2 | TCM 1 | TCM 2 |
|
|
|
|
|
4 | TCM 1 | TCM 2 | TCM 1 | TCM 2 |
|
|
|
|
|
5 | no connection | no connection | TCM 3 | TCM 4 |
|
|
|
|
|
6 | no connection | no connection | no connection | no connection |
|
|
|
|
|
Note: On the CallPilot 100, only TCM 1 and TCM 2 are available for use.
Note: It is very important that you ensure that the Feature Cartridge is inserted into the bottom PCMCIA slot before you power up the CallPilot unit.
3Insert the feature cartridge into the bottom PCMCIA slot of the CallPilot 100/150.
4Connect the other end of the TCM cables to station ports on your Norstar KSU.
Note: Do not connect the Ethernet cable for your LAN to the Ethernet port until you initialize the CallPilot 100/150.
CallPilot 100/150 Quick Start Guide