GE 2-9868 manual Installation, Plug the telephone line cord into a modular wall jack

Page 5

INSTALLATION

1. Plug the telephone line cord into a modular wall jack.

2.Connect the telephone line cord from your telephone into the jack on the back of the answerer marked PHONE. (You don’t have to connect your telephone in order for the answerer to record incoming messages.)

3.Connect the small end of the power supply into the POWER 9V AC jack on the back of the answerer. Plug the other end into an AC power outlet. The unit beeps 3 times and is ready for setup or to answer calls with the default greeting and settings.

NOTE: Only use the Thomson 5-2434A power supply that was packed with this unit. Using other power supplies may damage the unit.

INSTALLATION INFORMATION

•Never install telephone wiring during a lightning storm.

•Never touch uninsulated telephone wires or terminals, unless the telephone line has been discon- nected at the network interface.

•Use caution when installing or modifying telephone lines.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Digital Answerer Users Guide Interference Information FCC Registration InformationTable of Contents Installing the Battery Parts ChecklistBefore YOU Begin Modular Jack RequirementsPlug the telephone line cord into a modular wall jack InstallationRecording the Greeting SetupChanging the Settings Reviewing the SettingsSetting the Time Previous NextSET Setting the Rings to AnswerSetting the Incoming Message Length ALL NEW Setting the Security CodeAdjusting the Volume Previous ALL Answerer OperationMemo Erasing ALL Messages WAY Record Leaving a MemoTo access your answerer Remote AccessGeneral Product Care Service Problem Explanation/Solution Troubleshooting TipsIndex SymbolsWhat we will do Limited WarrantyPress Model Box 1976, Indianapolis, Rev E/S
Top Page Image Contents