AT&T 1725 Installation, Connect the line cord, Connect the telephone, Connect the power cord

Page 2

I N S T A L L A T I O N

1Connect the line cord.

Plug one end of the telephone line cord into the jack labeled TEL LINE on the back of the system. Plug the other end into a phone wall jack.

2Connect the telephone.

NOTE: If you do not want to connect a telephone, skip to Step 3.

Plug the line cord from the telephone into the jack labeled TEL SET on the back of the system.

3Connect the power cord.

Plug the power cord into the jack labeled POWER on the back of the system. Plug the power cord into an electrical outlet not controlled by a wall switch. Fit the power cord behind the strain relief tab. (When you connect the system to power, the Message Window flashes CL to indicate that you need to set the clock. See “Setting the Clock” in the OPERATION section of this manual.)

Image 2

Contents Deluxe Tapeless Digital Answering System with Mailboxes Connect the line cord InstallationConnect the power cord Connect the telephoneE R a T I O N Announcement Options Setting the ClockAbout Mailboxes Recording Your AnnouncementTurning the System On/Off Volume ControlReviewing Your Announcement Answering CallsSaving Messages Listening to Your MessagesPreviewing Messages Moving a Message to Another MailboxRecording a Memo Priority Call SignalWhen Memory is Full Recording a Phone ConversationChanging the Remote Access Code M O T E O P E R a T I O N Turn System Off Ending Remote Access CallChanging Your Remote Access Code Memory FullC a S E O F D I F F I C U L T Y Message Window Is BlankRemote Commands Tapeless Digital Answering SystemCommand Press