AT&T 1725 user manual Changing the Remote Access Code

Page 8

O P E R A T I O N

Changing the Remote Access Code

The Remote Access Code is preset to 500. You can change the Remote Access Code to any three-digit number from 500–999. DO NOT pick the same number as that assigned to the Priority Calling Code.

1Press g. The Message Window displays CH.

2Hold down cfor at least two seconds. The system announces “First digit.”

3Press /or ?to change the digit.

4When the Message Window displays the desired first digit, press c. The system announces “Second digit.”

5Press /or ?to change the digit.

6When the Message Window displays the desired second digit, press c. The system announces “Third digit.”

7Press /or ?to change the digit.

8When the Message Window displays the desired third digit, press c. The system announces the new Remote Access Code.

Image 8

Contents Deluxe Tapeless Digital Answering System with Mailboxes Installation Connect the power cordConnect the line cord Connect the telephoneE R a T I O N Setting the Clock About MailboxesAnnouncement Options Recording Your AnnouncementVolume Control Reviewing Your AnnouncementTurning the System On/Off Answering CallsListening to Your Messages Previewing MessagesSaving Messages Moving a Message to Another MailboxPriority Call Signal When Memory is FullRecording a Memo Recording a Phone ConversationChanging the Remote Access Code M O T E O P E R a T I O N Ending Remote Access Call Changing Your Remote Access CodeTurn System Off Memory FullC a S E O F D I F F I C U L T Y Message Window Is BlankRemote Commands Tapeless Digital Answering SystemCommand Press