AT&T 1854 manual SET UP System, TABLE/DESK Installation

Page 2

 

I N S T A L L A T I O N

Remove the Base

Install the Batteries

 

Press in on tabs.

Open battery compartment door

Install 4 AA batteries

Lift base off the phone.

SET UP SYSTEM

1Install the batteries.

Turn the unit upside down.

Push in on the two tabs at the large end of the base, and lift the base off the phone.

Press the battery compartment's tab, and swing open the battery compart- ment door.

Insert four AA batteries. Always use four new batteries.

Close the battery compartment door.

NOTE: When battery power is low, the LOW BATTERY light is on. Replace the batteries promptly to prevent the possibil- ity of memory loss.

2Set the Dial Mode switch.

Set the switch to TT (touch tone) or DP (dial pulse) telephone service, depend- ing on your telephone service.

TABLE/DESK INSTALLATION

1Attach the base.

Turn the base so that the larger end is toward the top of the telephone. Re- attach the base by inserting the tabs into the slots. Push down on the large end of the base to lock the base into place.

2Connect the line cord to the telephone. Plug one end of the cord into the jack labeled TEL LINE on the bottom of the phone. Place the line cord in the channel on the base.

3Connect the handset to the telephone. Plug the coiled cord into the handset jack on the side of the phone. Plug the other end of the coiled cord into the handset, then hang up.

4Connect the line cord to a modular jack.

5 Connect the power cord.

Use only the power cord supplied

!with your system. If you need a replacement cord, call 1 800 722 9125.

Fit the power cord behind the strain relief tab. Then, plug the smaller end of the power cord into the POWER jack at the back of the system.

Plug the power cord into an electrical outlet not controlled by a wall switch.

6Wait for the system to initialize. When the system is connected to AC power, all the indicator lights flash on and off. The Message Window counts down from eight to zero.

After the system reaches zero, you can complete installation by following instructions in "Setting the Clock."

Image 2
Contents Telephone with Caller ID TABLE/DESK Installation InstallationSET UP System Selectable Dial Information Wall InstallationSetting the Clock Wrap the line cordL E P H O N E O P E R a T I O N L E P H O N E M E M O R Y L L E R I D E N T I F I C a T I O N S W E R I N G S Y S T E M O P E R a T I O N Turn answering system On or Off Play messagesRecord AN Announcement SET UP Call Match AnnouncementAnnouncement Options Review AN AnnouncementNumber of Calls Answered By Call Matching SET Remote Access CodeWhen Memory is Full Audible Message AlertConnect with Answering System Change Remote Access CodeVoice Activated Commands Play MessagesC a S E O F D I F F I C U L T Y Other Problems Call Match Announcement Not Played