Avaya 3600 Series Modes of Operation, Standby mode Active mode Push-to-talk mode 3626 WT only

Page 9

Avaya Inc.

Desktop Charger, Dual Charger, and Quad Charger User Guide

Modes of Operation

Standby mode

Active mode

Push-to-talk mode 3626 WT only

The WT uses different amounts of power and bandwidth in different modes of operation. Bandwidth is provided by access points located throughout your facility. Bandwidth availability varies by type of access point. The Battery Pack in your WT provides about four hours of talk time or 80 hours in the standby mode (see below).

If push-to-talk (3626 WT only) is allowed in the Admin menu and enabled by the user, standby Battery Pack life is decreased to about 30 hours.

Conservation of battery life and bandwidth is possible when you understand the modes and use them appropriately.

In the standby mode the WT is waiting for an incoming call or for the user to place an outgoing call. The extension number is shown on the display and there is no dial tone. In this mode, the WT is conserving battery power and bandwidth.

You may set certain preferences in the user option menu described later. This menu is accessed from the standby mode.

It is important to return to the standby mode after finishing a call by pressing the End Call key. Unless otherwise directed, the following instructions for using the WT assume that it is in standby mode.

To place a call, press the Start Call key. This transitions the WT to active off-hook mode. There is a dial tone, the WT is in communication with the PBX, and the display shows information as it is received from the PBX.

The WT is also in the active mode when you receive a call.

In certain PBX integrations, some features are designed to be accessed from an active on-hook mode. To go on-hook while still active, you may be directed to press the Line key or a Release feature key.

.

Whenever you are in active mode, whether off-hook or not, the WT requires the most bandwidth of any mode.

To conserve bandwidth and battery power, when you have completed a call or are finished accessing active mode menus and features, press the End Call key to exit the active mode and return to the standby mode.

The push-to-talk mode utilizes a common channel for incoming and outgoing radio communication. Outgoing communication uses the same amount of bandwidth as the off-hook mode. Incoming communication uses about half as much.

21-300632, Issue 1, July 2005

Page 9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Avaya 3600 Series Wireless IP Telephone 2005, Avaya Inc Table of Contents 21-300632, Issue 1, July 3616 WT 3620 WT 3626 WT Overview Status IndicatorsModes of Operation Standby mode Active mode Push-to-talk mode 3626 WT onlyBasic Operation WT Headset System Feature Activation Using the Softkeys Ring Options Setting User PreferencesNavigation Lock keysRing options Telephone ring System info Auxiliary ring Phone optionsExtension Push-to-talk PTTPush-to-talk operation 21-300632, Issue 1, July 21-300632, Issue 1, July 21-300632, Issue 1, July 3616, 3620 Battery Pack removal and replacement Battery Packs21-300632, Issue 1, July Desktop Chargers 21-300632, Issue 1, July Dual Chargers Show charging progress. The handset is fully operational Quad Chargers 21-300632, Issue 1, July Important Notes about Chargers and Battery Packs General Care of the WT and Chargers Please Note Tips For UseDeclaration of Conformity Regulatory Information2Operational Warnings Radio Frequency RF InformationFacilities Electromagnetic INTERFERENCE/COMPATIBILITYInternational Certifications Z233IDA Specific Absorption Rate SAR Information
Top Page Image Contents