6.Press ENTER→ Router→ Press SPD/HOLD→ Blinking Cursor→ Input Default Gateway Information (XXX*XXX*XXX*XXX) and the press ENTER.
5.1.3. PPPoE Setting
1.Connect the power adaptor of
2.Press1234# (Hold the “#” key) → [Password] → Press 1234 and then press ENTER→ Network Settings.
3.Press ENTER→[iptype] →press SPD/HOLD→ Blinking Cursor→ Press 1 and then press ENTER (1 sets your networking settings PPPoE)
4.Press ENTER→[pppid] →Press SPD/HOLD→ Input PPPoE Account Number and press ENTER
5.Press ENTER→[pppin] → Press SPD/HOLD→ Input PPPoE Password and press ENTER→ Press ENTER again to complete the configuration
※Refer to the attached appendix when inputting special Symbols such as @, A, a, B, b, C
5.2. Protocol Settings
1.Press1234#( Hold the “#” key)→ [Password]→ Press 1234 and then press ENTER→ Network Settings Press1234#( Hold the “#” key)→ [Password]→ Press 1234 and then press Enter→ Network Settings→ Press Vol.- (volume decreasing button)→ [Protocol Setting]
2.Service
Press ENTER twice in the [protocol settings] prompt→ Service z Press SPD/HOLD, “0” and then ENTER to disable service z Press SPD/HOLD, “1” and then ENTER to enable service
3.Configure the proxy server registrar location of the
Press ENTER 4 times in the [protocol settings] prompt→ [service address]→ Press SPD/HOLD→Enter the IP address of the registrar proxy server(XXX*XXX*XXX*XXX) and then press ENTER.
4.Enable STUN for NAT
On prompt of [protocol settings] press ENTER 5 times→ [nat traversal] → press SPD/HOLD→ press “4” to enable STUN and then press ENTER→ press ENTER again→ [nat addr]→ press SPD/HOLD→ Input the IP address of the STUN server(XXX*XXX*XXX*XXX) and then press ENTER.
5.If
On prompt of [protocol settings] press ENTER 5 times→ [nat traversal]→ press SPD/HOLD→ press “0”and then ENTER to disable Nat
6.
On prompt of [Protocol Setting] press ENTER once→ Press VOL＋ (the volume increasing button) 3 times→ [local type] → Press SPD/HOLD
10