ArtDio IPF-2000 user manual Dhcp Settings, Static IP Setting

Page 9

IPF-2000 User Manual

Figure below shows the options of the Main Menu:

5.1. Network Settings

The default setting for IPF-2000 is DHCP . Therefore, IPF-2000 will be able to connect to the internet under any DHCP environment.

If the network environment is either PPPoE or Static IP, please change the networking setting of IPF-2000 to its corresponding network environment.

Enter keypad configuration mode and select [network setting]. Select either DHCP, Static IP or PPPoE based on your network environment on the phone.

5.1.1. DHCP Settings

1.Connect the power adaptor of IPF-2000 and connect the PPPoE network to the IPF-2000 to its RJ-45 port.

2.Press 1234# (Hold the “#” key) Æ [Password] Æ Press 1234 and then press ENTER Æ Network Settings.

3.Press ENTER Æ [iptype] Æ press SPD/HOLD Æ Blinking Cursor Æ Press 1 and then press ENTER (1 sets your networking settings to DHCP).

5.1.2. Static IP Setting

1.Connect the power adaptor of IPF-2000 and connect the PPPoE network to the IPF-2000 to its RJ-45 port.

2.Press1234# (Hold the “#” key) → [Password]→ Press 1234 and then press ENTER→ Network Settings.

3.Press ENTER→ [iptype] →press SPD/HOLD→ Blinking Cursor→ Press 0 and then press ENTER (0 sets your networking settings to Static IP).

4.Press ENTER→ [IP] →SPD/HOLD→ Blinking Cursor→ Input IP address (XXX*XXX*XXX*XXX) and the press ENTER.

5.Press ENTER→ Subnet Mask→ Press SPD/HOLD→ Blinking Cursor→ Input Subnet Mask information (XXX*XXX*XXX*XXX) and then press ENTER.

9

Image 9
Contents ArtDio Company Inc Safety Instructions Hardware Installation Keypad Configuration Table of ContentRegistration Message Using IPF-2000 Product Specification IPF-2000 Function Illustration Package ContentsKeys Function Rear and Back Panel Function Keys IntroductionKeypad Configuration Hardware InstallationStatic IP Setting Dhcp SettingsPPPoE Setting Protocol SettingsAudio Settings Other SettingsSet IPF-2000 handset and speaker phone volumes Revert Back to Factory Default Speed dial SettingsSave Settings Exit SettingWEB Configuration Page Network NetworkProtocol ProtocolNat traversal Service idNat addr Nat ttlPhone Phone Audio AudioOthers UpdatePhone Book OtherRegistration Message Using IPF-2000Appendix Programming KeysFrequently Ask Questions