Automatic pause insertion
If your PABX requires a pause after dialling the outside line access code, this can be inserted automatically by programming the telephone.
e.g. If the access code is "9", the telephone can be programmed in the following way
-press store
-press "9"
-press store
-press " * "
Whenever a telephone number that begins with the access code is dialled - "9" in this example - a 3.6 second pause will automatically be inserted after the access code has been dialled.
To cancel this feature
-press store
-press store
-press " * "
Voice Messaging
When used behind a PABX, this telephone will respond to voice messaging systems on specific PABX types. Your telephone manager should be able to advise you.
As supplied, the telephone will respond to high voltage message signalling. If your system provides reverse polarity message signalling, then the follow- ing action will have to be taken before your telephone will operate correctly.
Refer to figure 1 on page (6). Remove the telephone from the line and then remove the lower memory overlay card.
The switch marked S/N should be moved from "N" to position "S". When the telephone is connected to line and voice message signals are received, the message light should flash or stay on( system dependent ).
18