Furuno ARP-17 manual Diagnostic Sequence, CPA Tcpa

Target	Course	Speed	CPA*	TCPA*
Target 1	90.0° R	10.0 kt	1.0 nm	10.4 min
Target 2	0.0° R	0.0 kt	4.0 nm	—
Target 3	180.0° R	10.0 kt	1.7 nm	28.2 min
Target 4	216.5° R	23.8 kt	0.9 nm	15.0 min
Target 5	273.5° R	14.2 kt	6.0 nm	22.5 min
Target 6	180.0° R	20.0 kt	0.0 nm	30.0 min
Target 7	24.6° R	15.6 lkt	4.0 nm	43.6 min

* Initial data

4.The simulation continues for five minutes and then repeats. To quit the test se- quence, turn the TRACK TEST off on the PLOT MENU2.

14. Diagnostic Sequence

You can check the ATA Board for proper op- eration as follows. The self test does not re- quire operator intervention. It runs automatically when the power is placed on at regular intervals or on operator demand.

1.Press [MENU], [0], [0], [0], [0].

2.Press the [2] key twice to start the diag- nosis sequence. The results of the test appear as shown below.

FR-1500 M-3 Series Test
1.	Program No.	03591521**
2. ROM Check		OK
3. RAM Check		OK
4. Antenna Rotation		24RPM
5.	Tx Trigger Frequency 3000Hz
6.	Video Level	000
7.	Video Signal	OK
8.	Navigation I/O 1	OK
9.	Navigation I/O 2	OK
10. NMEA Heading IN OK
11. LOG Pulse IN		OK
ARP TEST
1.	Program No. 18590411** 18590421**
2. ROM Check		OK	OK
3. RAM Check		OK
4. Speed Log		OK 0.0 KT
5.	Course	OK
6.	Trigger	OK
7.	Video Signal	OK
8.	Bearing Pulse	OK
9.	Heading Pulse	OK
10. Minimum		0003
11. Scan Time		0274
12. Manual Acq.		00
13. Auto Acq.		00
14. FE-Data 1		0000
15. FE-Data 2		0000

Press MENU key to escape.

Press ENTER to check CRT.

** Program No.

Figure 13 Diagnostics test results

(FR-1500 MARK-3 series)

3.If NG appears for any ATA-related item, call for service.

4.To escape, press the [MENU] key.

12