Telex XO-AP XO-1 manual Beltpack Options, Login telex Enter Password legacy Enter

Page 12

9.Press and hold down the “X” button on the beltpack. Keep holding the “X” button and turn-on the beltpack. Hold the beltpack button down until the green LED next to the “X” button lights up (about 20 seconds), then release button (Places the beltpack in programming mode).

10.Plug the other end of the Ethernet cable into the beltpack.

11.Type, telnet 192.168.1.X at the computer’s command prompt, then press <ENTER>. Fill in for X the last digit of the IP address that is on the back label on the XO-1.

12.After about 20 seconds the beltpack will respond with a login request. Enter the following:

Login: telex <ENTER>

Password: legacy <ENTER>

NOTE: The password entry does not give user feedback to the screen.

NOTE: If the computer says, “failed to connect”, turn off the XO-1, check computer settings, and go back to step 6.

Beltpack Options

Once successfully logged into the beltpack you will be presented with the following screen:

1. Enter new password

This option allows the user to change this XO-1’s password. The default from the factory is legacy. The user is never allowed to change the login name of telex.

2. Enter new encryption key

The user must change the encryption key if this option is selected.

1.When “2” is selected the phrase, “Enter new encryption key” appears.

2.Now enter the new encryption key. The maximum length is 80 characters. Any combination of letters/numbers/punctuation may be used. Even a sentence such as, “My offensive is number 1 in the state”, may be used as the key. The key is upper and lower case sensitive.

NOTE: A character is letters, numbers, punctuation, spaces, etc.

NOTE: The “backspace” keyboard button may not work on all computers using Telnet, use the delete button instead if this is the case.

CAUTION: Write down the key or use one that you can remember, because ALL beltpacks must have the same key entered in order for communication.

3.Press <ENTER> after the key is typed. This will place the key in the software. Reboot the beltpack for the new encryption key to take effect.

3.Exit

The three options on this screen are as follows:

This exits the login and closes the connection to the beltpack.

6-2

Image 12
Contents Operating Manual Table of Contents System Features IntroductionGeneral Description XO-AP Base Station Controls and ConnectionsFront View Rear ViewXO-1 Beltpack Top ViewBottom View Specifications Legacyä Technical SpecificationsOperation Set-upSystem Operation XO-AP and Panel AntennaTop View Bottom View Halftime Before the Next UseLong Term Storage Charging InstructionsLi-Ion Batteries Encryption Code Encryption CodeLogging into a Beltpack XO-1 Login telex Enter Password legacy Enter Beltpack OptionsTroubleshooting Problem Possible Cause SolutionTroubleshooting RF Channels RF ChannelsRegulatory Information Regulatory InformationAccessories and Replacement Items Accessories and Replacement Items ANT-FPMEast Cornhusker Highway, Lincoln, NE