|
|
|
| Section 3 - |
| |||
|
|
|
|
| Controls and Connections |
|
|
|
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 |
|
|
|
| |||||
| Telex R | BATTERY |
|
|
|
|
|
|
| MIC |
| TALK |
| MIC + |
|
|
|
| OFF |
|
|
| CHG |
|
| EXT |
| O |
| X |
|
|
| ||
|
|
|
|
|
|
Top View
1.On/Off & Volume Control – Turns the beltpack power on/off and controls headset volume.
2.Battery Light –
•GREEN - Battery OK
•RED - Battery Low (needs charged)
3."O" Channel Button and Light – Selects the “Offense” intercom channel. The light next to the button will light when selected. Also controls headset Mic
•Mic
4.Talk Button – When pressed the microphone path is enabled. This button has two operational modes:
•Momentary – Pressed and hold for over ½ second.
•Latch on/off – Tap button and the microphone path is enabled. Tap again to turn off.
5."X" Button and Light – Selects the “Defense” intercom channel. The light next to the button will light when selected. Also controls headset mic (+) level:
•Mic (+): Press and hold talk button, then press and hold "X" button. Listen for voice prompts in headset. Adjust headset mic level higher (+).
6.Charge Jack – Used to charge the internal battery. Accepts a 5.5mm x 2.5mm plug with the center positive. Must be supplied with a 12VDC regulated power supply with at least a 400mA current capacity.
Bottom View
7.Charge Light.
•RED = Beltpack battery is charging.
•GREEN = Beltpack battery is charged.
8.Headset Connector – Standard
•Pin 1 = Microphone GND
•Pin 2 = Microphone HOT
•Pin 3 = Headphone +
•Pin 4 = Headphone –
9.Programming Jack – This