Unit Scan
Unit Scan is used to make IP address assignments to the hardware. With the Unit Scan window open click the Scan button. When the equipment list appears, double click each address and change it to match what you were given by the network administrator and press enter to save each setting. Once you have assigned the devices unique IP addresses, put a check in the box next to each device and hit Configuration to save those settings to the devices. You may then close the Unit Scan window.
At this point we should also change the computer’s
IP address to be on the same subnet our equipment is on. |
|
|
|
|
|
Note: In this example, the |
|
|
this happens check power, or wait 30 seconds and try again. |
|
|
| Figure 2: Unit Scan | |
|
| |
Equipment List |
| |
|
| |
|
| |
The Equipment Registration tab of the General section is |
|
|
used to tell the software which devices our system will use. |
|
|
The Content section of the Equipment Registration |
|
|
tab should be filled out with the appropriate quantities of |
|
|
each item in your system so the software is aware of each |
|
|
part of your system. Change each line in the Content |
|
|
section from 0 to the correct quantity and press enter, for |
|
|
each device an Equipment No. row will appear at the |
|
|
bottom with a set of default settings. |
|
|
Each Exchange, IP Station (whether a door or a |
|
|
master) and Multi Interface requires an IP address to |
|
|
communicate with each other (the IP address we assigned |
|
|
in Unit Scan). You may import these IP Addresses using the |
|
|
button. When the window pops up, you will | Figure 3: Equipment Registration, see page 150. | |
see the Equipment No. items from before as |
|
|
well as a blank area on the bottom. |
|
|
Hit the “Scan” button and you will see the result of |
|
|
your Unit Scan from before on the lower half of the |
|
|
window. One at a time select an item from the lower half |
|
|
(the correct settings) and an item from the top half (the |
|
|
default and incorrect settings) and click Import so the |
|
|
software and the Unit Scan agree on your IP addresses. |
|
|
Click OK when you are done. |
|
|
You can also manually enter in the correct IP |
|
|
addresses without using the Import from Scan Result |
|
|
window, but it is highly recommended to use Unit Scan to |
|
|
verify that your equipment is connected to the network, has |
|
|
unique IP addresses before you get to this point, and to |
|
|
prevent problems when you upload for the first time. Be |
|
|
sure to press Enter after changing an IP address, so the |
|
|
program accepts the change. |
|
|
You now should have a complete Equipment list. |
|
|
Note: If you aren’t installing every station today you should still add them to the equipment list. They can be quickly added to the system later using Unit Scan and Uploading the configuration settings.