Message for entrance, Entrance monitoring

8-3 Message for entrance

1 During communication, instant voice call or entrance monitoring, press MENU/MEMO button to display the menu screen.

3 Press either CALL button or PLAY button. The selected Message changes to yellow, "SENDING MESSAGE" is displayed, and the selected message is played from door station.

SEND MESSAGE FOR ENTRANCE

SENDING MESSAGE

English

	2 Press PLAY button.			NOTES: Record separate messages in advance for Message 1 and
	2 Press PLAY button.			Message 2. (Refer to section 7-6)
				Message 2. (Refer to section 7-6)

PRESS THE TALK BUTTON TO END

Français

8-4 Entrance monitoring

1 Press MONITOR button in the standby mode.

2 The video monitor displays the image from door station 1 and the incoming audio is heard. If you do not press TALK button, the caller will not hear sounds from the inside station.

3Press MONITOR button again to switch to door station 2. Each time MONITOR button is pressed, the unit switches in the sequence "Standby" to "Door station 1 monitor" to "Door station 2 monitor" to "Standby".

When "Audio door station" or "Door station 2 not connected" is set in the door station 2 setting, "Door station 2 monitor" is skipped (door station 2 cannot be monitored). (Refer to section 7-7)

4Press MONITOR button again to end.

Nederlands

NOTES: 1. To talk to the entrance during monitoring, momentarily press TALK button. Press TALK button again to end communication.

2. The entrance monitoring turns off automatically after approx. 1 minute. To monitor the entrance again, repeat from the beginning.

8-5 Room-to-room communication

1 Press CALL button to talk with the other person.

•CALL button (red) flashes and the "All Call" function is activated to link all the master/sub stations.

•The reply of the other person is not heard.

2 If the other person presses TALK button, hands-free communication is possible.

Do not press TALK button during communication. It will end the commnication.

3 Press and release TALK button to end.

NOTES: 1. Room-to-room communication ends automatically after approx. 10 minutes. To perform room-to-room communication again, repeat from the beginning.

2.If a call is received from the entrance during room-to-room communication, a chime tone sounds from the monitor station and sub station where communication is taking place. Press TALK button to end the room-to-room communication, and press TALK button again to switch to communication with door station from which the call was received.

- 11 -