Datalogic Scanning Pegaso manual Connection to +24V, +36V and +48V Systems, Dc/Dc

Electrical System Connections

Connection to +24V, +36V and +48V Systems

Figure 5 illustrates a wiring diagram for +24, +36 and +48 volt systems. The use of a DC/DC converter is required to step down the battery voltage for use by the PDA.

	Proper installation requires that source power connections be made directly
	to the mobile platform’s positive and negative battery terminals. It is
	important to maintain electrical isolation when installing the PMD and any
CAUTION	accessory equipment, to ensure safe and proper operation. Do not make
	any electrical connections directly to the chassis of the forklift.

When using any optional equipment caution must be taken to ensure that +24, +36 or +48VDC does not exceed any voltage rating for these devices. Fol- low all manufacturer's installation instructions carefully.

Some DC/DC converters provide internal Noise Spike/RF filtering. The use of an additional filter is optional.

Figure 5. Wiring Diagram for +24V, +36V and +48V Systems

		DC/DC
		Converter
	In-Line Fuse	(Required)		5 Amp In-Line Fuse		Power Cord
(integral to converter)
					(Required)	Red (Pos)
Pos		Pos	+
+		IN	OUT			Black (Neg)
Neg		Neg	-
-

Use crimp connectors for all wire connections

Installation Guide 9