Casio IT-2000 installation manual Installation Method

2.3Installation Method

This section describes the installation and setup procedures that must be performed before I/O Box and PC operations are started. The following diagram shows a flow of the setup procedure.

Fig.2.6 Installation flow of IT-2000

(If Master I/O Box is used) Mount SCSI Board in the PC and install the SCSI driver

Install Upload/Download

Utility in the PC.

Turn OFF the power of the

PC.

Set the DIP switch of I/O Box.

Connect each cable between I/O Boxes.

Connect cable between the PC and I/O Box.

Connect AC adaptor for each I/O Box.

Turn ON the power of all the I/O Boxes.

Turn ON the power of the PC.

Star up the Upload/Download Utility and set the environment.

Note:

For information about the installation procedure of the Upload/Download Utility refer to the Upload/Download Utility Manual.

For information about the I/O Box setup refer to Chapter 2.3.1 “Setup of Satellite I/O Box”, Chapter 2.3.2 “Setup of Master I/O Box”, and Chapter 2.3.3 “Setup of Satellite I/O Box to

￿Master I/O Box”.

For information about the setup of Upload/Download Utility environment refer to Chapter 2.3.4 “Setup of PC”.

8