Casio PA-2400W manual Error Code Meaning Possible Cause Remedy

Table 7.6 List of termination codes

Error Code		Meaning	Possible Cause	Remedy
Category	Detail
code	code
00h	00h	Normally terminated	Normal.	-
DCh to	00h	Normally terminated	Formatting of drive a:between 'A'	Refer to Chapter 7.5
F5h			and 'Z' is specified from the	“Restrictions”.
			partner station. (For drive letter
			definitions, refer to Chapter
			7.7 “Method of Describing
			Pathname”.)
F6h	00h	Normally terminated	Power-off is specified from the	Turn off the power.
			partner station.
F7h	00h	Normally terminated.	Resetting the power is specified	Refer to Chapter 7.5
			from the partner station.	“Restrictions”.
F8h	00h	Terminated due to interruption.	Communication is terminated	Resume communication as
			because the break key is pressed	required.
			on the PA-2400W (local station)
			or partner station.
01h	00h	Protocol error	Data anomaly (data error	Check the communication
			occurred on the communication	line connection.
			line).
02h	80h	File not found	Non-existent file is specified.	Check the specified file or
				directory.
02h	81h	Current directory delete error	An attempt has been made to	Check the objective
			delete the current directory.	directory of deletion.
02h	82h	File write error	Write to the file is not possible.	Check if the file is ready to
				be written.
02h	83h	File read error	Read from the file is not possible.	Check if the file is ready to
				be read from.
02h	84h	Read only access error	An attempt has been made to	Specify another file name or
			overwrite or delete the read-only	cancel the read-only
			file.	attribute.
0Fh	01h	Argument parameter error	Incorrect argument description	Check the argument
				parameter.
0Fh	02h	Argument too long	Argument portion of the	Reduce the length of the
			command line is too long	argument including FLCE to
				255 characters or less.
A0h	10h	Communication port open error	One of the other programs is	Terminate the program that
			using COM1 or IrDA,or FLCE is	is using COM1 or IrDA.
			already initiated.
A0h	20h	Line break error or IrDA	Either the cable was unplugged	Check the cable connection
		duplicate open error	during communication or the	and mounting condition of
			IrDA connection is broken	the PA-2400W on I/O Box.
			(where the PA-2400W is
			dismounted from I/O Box).
			IrDA port is already open.	Terminate the other
				program that is using IrDA.
A0h	30h	Session-wait timeout error	Session was not established	Check the cable connection
			within 1 minute of startup.	or check if the IrDA is ready
				for communication.

55