Unitech PA962 Installing the Wireless Local Area Network Wlan Card, Setting Up the Wireless Card

Installing the Wireless Local Area Network (WLAN) Card

=Power off the PA962.

=Remove the stylus, using the screw driver in the stylus to remove the screw, and then open the PCMCIA compartment.

=Attach the snap-on antenna to the RF card if required (only the Cisco card comes with a pre-installed antenna).

=Attach pulling-tag to antenna.

=Insert the RF card into the PCMCIA slot.

RF Card Cushion

PCMCIA card front side

Remove the protective backing from the sticky side of the RF Card Cushion and install the cushion along the inside upper edge of the PCMCIA Cover as shown. The RF Card Cushion prevents damage to the RF card antenna in case the PA962 is accidentally dropped.

Re-attach cover to the PA962

Setting Up the Wireless Card

The PA962 is pre-loaded with connection software from Cisco and Lucent WaveLAN (Agere Orinoco). The PA962 will automatically detect these RF cards and then display the following screen during the first-time installation. Please note that there are two ways to set the IP address:

38 Unitech PA962